10mm U Notch Trowel OK for for wall tiles?

[siremastimus]

Hi, I have a 10mm Rubi u notch trowel I was planning on using for floor tiles - could I also use these for the wall tiles - the wall tiles are 25 cm x 38 cm ceramic tiles - walls arent too bad, not 100% level but perhaps 5mm out at worse point? Thanks

 

[Alan.P]

Sure you can, maybe a little overkill but if the walls are slightly out then it can only help.

 

[Time's Ran Out]

It should certainly give you solid bed fixing!
But what adhesive are you using?

 

[Dan]

You'll use a fair bit of adhesive with a 10mm U notch to be honest. Might be worth paying for a 6MM square or something (even 10mm square) and the costs you save on adhesive should far outweigh the cost of a trowel.

 

[siremastimus]

OK thanks, was going to use KeraFlex - maybe I will get a square on too for walls