365 drills

[cooper]

well guys ,just recived my drills today and got to say they work .i may sound surprised but when you these programms about new products, well sometimes you buy them and when you get them they do not work,but let me tell you if you have hard tiles to drill these drill bits do work

 

[Deleted member 1779]

In a happy coincidence we just recieved an e-mail from a customer saying practically the same thing! And the two compliments were only 15mins apart! We always love to hear from our customers. And yes agree some things need a leap of faith when ordering. But yes they do work!!!

Copy of email
================================
Hi,received item today and got to say great drill bits ,took me about 30 mins to cut all holes for me shower controls.
stefan ***czko

========================================
Message Received: May 24 2011, 06:34 PM
From: "365 GROUP"
To: "stefan ***czko"
Cc:
Subject: 365 Group Despatch Note for order ref: RC9831960

Dear Mr ***czko,

You will be pleased to know that the following items from your order RC9831960 have been despatched.


1 x 365Drills Bathroom Fitters Kit. All-in-one solution. SEVEN diamond drills in 5 essential sizes


Once again we would like to thank you for shopping with 365Drills
==========================================================
​

 

[Gazzer]

Been drilling some tough porcelain today and they have been great.

 

[hillhead]

I drilled eight 30mm holes in 600x600 italian polished porcelain on saturday and the bit was kept nice and wet.
It didn't even heat up !!!
I can't wear them out !!!! not the bigger sizes anyway.
Keep up the good work Richard.

 

[user123]

oh, Richard, while you're on line - do you think it's safe to drill a hole into curved glass, as in a pintglass or similar? it's thin ... but failure is not an option.. got your set.. JOTM prize..

 

[Deleted member 1779]

Bottom line is YES
If its possible then we suggest going through both sides. If not then take your time. Dont apply too much pressure to the glass. We have just done some aquarium shows and I will be doing a few videos later this year to demo drilling glass.

The yellow plate flexes to the glass to fit. So very simple.

 

[Deleted member 1779]

Here is the video for demo on drilling glass. Taken from part of a previous video. (I just cut out the glass drilling section).
When I get time I will do that glass drilling demo video properly!

[video=youtube;1wotpK5hVss]http://www.youtube.com/watch?v=1wotpK5hVss[/video]

How to drill holes in glass. If you need drilling holes into glass. Either round or flat then PORSADRILL will work.