Adhesive stuck to tiles

[Hulloo]

Hi....Ok so ive made a bit of a silly mistake. Ive tiled a bedroom wall with some ceramic tiles. problem is ive left a few blodges of the adhesive to dry on the tile surface. i used homebase waterproof tile adhesive and grout in one. Any ideas of to remove this without damaging the tiles....taaaaaa

 

[Gazzer]

Just wet it and rub it off.

 

[Hulloo]

Just wet it and rub it off.

its dried and quite tough to remove

 

[Gazzer]

If you wet it it will soften up.

 

[Hulloo]

If you wet it it will soften up.

ok ill give another go...best to use warm or cold water??? plus what could i use to scrub it without damaging....it was ready mixed adhesive and grout in 1

 

[White Room]

I'd use a bit of warm water.....

 

[Hulloo]

are there any products which can help with this? it still feels at it needs some effort to remove and do not want to dammage the tiles

 

[White Room]

Use a clean piece of soft pine wood to avoid scratching the tile surface.....

 

[Dan]

Should come off quite easily. Tile adhesive and grout in one, is poor for either an adhesive or a grout. You should be able to wet it (perhaps try to soak it a bit with a wet towel or something if it's in an area possible to do so - maybe even lean a mop up against it that's wet?) and then just wipe it off. It'll break back down to a paste if it's been wet long enough. Hence it being no good for most types of tiling.

 

[EverDon Tiling]

Homebase all in one take a deep breath hold it.........now blow it off :lol:

 

[afright]

Tile and grout rubbish, bin it! worst stuff on the market.

 

[AliGage]

Just out of interest, what are the tiles?

 

[2tone]

Soaked well with warm water and soft wood to remove.
Job done