chipping of tiles

[Handyeire]

Was cutting some ceramic floor tiles earlier with my small plasplug wet saw and the blade become blunt and wouldn't cut the tiles so I popped off to few local hardware stores and coukdnt get a replacement blade. I decided to use my dry blade on the grinder(I only use this for cutting out square sockets or light switches) and even thou I got some cut, the dry blade was leaving me with small chipped tiles

Ended up phoning a guy I know who had a vitrex small blade, put this on my plasplug cutter and was getting a bit of blade wobble and some chipped tiles again

What I'm wanting to know, is there any dry blades that don't leave a chipped tile when cutting and does all vitrex blades wobble/leave a small chipped effect on the cut.

 

[White Room]

Try http://www.atsdiamondtools.co.uk/

 

[NWTiles]

For a gringer use a RUBI TCR 115 Blade.

 

[Chalker]

With above^^^^^^

 

[Time's Ran Out]

You have to get yourself a decent cutter.

 

[Dave]

Use water in your wetsaw...

 

[Handyeire]

You have to get yourself a decent cutter.

Saving for one as we speak thou I didn't have these problems with the plasplug blade.

 

[Handyeire]

Use water in your wetsaw...

Must remember that one, thanks

 

[Dash J]

Mate you need loads of water in your cutter,those wee machines require loads of water
the beauty of those small blades is they shouldn't wobble
i only use a small wet cutter for splash backs
I find the bigger blades have a tendency to jam sometimes