drying times on new screed

[Andy Allen]

looked at a floor to day the oversite has been down a couple of months and a 2 inch sand and cement screed is going on top in the next few days the customer wants it tiled a.s.p ive said 6/7 weeks do you think it could be done sooner if the warm weather continues the builder says hes putting fibers in the mix dose this make any difference with the drying times? its about 25m2

 

[DHTiling]

screed will dry faster than concrete..

You can use a green screed adhesive or a vapour equalisation membrane to hurry things along..

 

[Andy Allen]

thanks dave think there a bit to tight to splash out on bal green screed do mapie do a cheaper version?

 

[Time's Ran Out]

thanks dave think there a bit to tight to splash out on bal green screed do mapie do a cheaper version?

You've been advised the correct way and that should be relayed to the customer.
Its then their decision to go with the small additional cost or wait!
Using any other adhesive not recommended for green screed will have a tendency to come back and bite your :smilewinkgrin:

 

[DHTiling]

Mapei Ultra flex S2 is suitable for green screeds and on special offer at CTD... not sure if this is a stock item in Tile giant..

 

[negsy26]

i have this problem too with a slate floor that customer wants done asap.screed has been down a few days and it has ufh. any suggestions on time ?

 

[nybor62]

drying time 1mm per day

 

[The Legend; Phil Hobson RIP]

As Dave has said, a vapour equalisation membrane eg. Schluter Ditra or Dural CI. you can lay on green screeds much earlier than the 1mm per day rule. It is never very practical imo to wait 80 days for 80mm screed

 

[nybor62]

As Dave has said, a vapour equalisation membrane eg. Schluter Ditra or Dural CI. you can lay on green screeds much earlier than the 1mm per day rule. It is never very practical imo to wait 80 days for 80mm screed

i totally agree with you phil

 

[easyt]

This thread has set off a few alarm bells for me - perhaps unnecessarily. I have to replace some areas of failed screed before tiling. I was going to give the areas a week. They are hopefully smallish areas and are 40mm thick at a guess.

20 years ago I replaced some screed in a sitting room (an area possibly 800mm x 1500mm) and probably tiled over within the week. No problems yet. Was I luck or is it simply that as the areas were relatively small so was the shrinkage.

Easy T

 

[White Room]

Could use a faster setting cement for the smaller areas