Expansion Gap

[ragged13]

Hi there, would anyone advise me on how big should be my expansion gap if I use large tiles (415x315 with 8mm depth),

also, corners are never even, so If I leave 10mm gap I wont have similar corner gap,

so should I keep measuring and cut them with different sizes to achieve a straight line up to cilling?

Thanks!

 

[White Room]

Post moved to start afresh

 

[peteablard]

You should centre the wall to give yourself the largest possible cut up each side, you can follow the contour of the edge with each cut. Leave approx 2-3mm gap then Silicon after grouting but don't grout this gap.

 

[The Legend; Phil Hobson RIP]

You should centre the wall to give yourself the largest possible cut up each side, you can follow the contour of the edge with each cut. Leave approx 2-3mm gap then Silicon after grouting but don't grout this gap.

Can't fault you Pete, spot on advice.

 

[nybor62]

ditto

 

[ragged13]

You should centre the wall to give yourself the largest possible cut up each side, you can follow the contour of the edge with each cut. Leave approx 2-3mm gap then Silicon after grouting but don't grout this gap.

Hi there

As you know I have 4mm spacers, so wouldn't my corners look unprofessional if I have only 2-3mm gap?

Shouldn't I stick to exactly same 4mm gap?


Of course Im gonna use Silicon.

Regards

 

[peteablard]

I didn't know that because you never said! However the joint size doesn't matter as they will be grouted and the corners should be siliconed so you won't see them

 

[ragged13]

I've decided to use mapei colour silicon so I really want expose this gap to make a nice level finish.

Grout between tiles, but not for corners.

I use 4mm spacers, and I keep 4mm gap in corners too.

 

[Aston]

good advice pete.

 

[AliGage]

I've decided to use mapei colour silicon so I really want expose this gap to make a nice level finish.

Grout between tiles, but not for corners.

I use 4mm spacers, and I keep 4mm gap in corners too.

Come again??

 

[ragged13]

Come again??

Yes, because I don't get : "the joint size doesn't matter" advice.


If you use a tick tile, like in my case, I don't think that the joint doesn't matter. Thick and large size tiles plus bigger joints.


All I wanted to know now is if I use 4mm spacers between tiles should I have 4mm gaps in corners too.

I think yes, but Would be great to hear it from you guys.

Regards

 

[AliGage]

I think 2-3mm (the norm) would be fine, as you will be siliconing over the corner joint anyway, and the Silicon joint is likely to be 5-6mm anyway.

 

[ragged13]

Thanks for a quick response.

Thats all I wanted to know

 

[AliGage]

Your welcome.