Fitting a Coram slimline shower tray with tile adhesive

[Speedoman]

Hello

Has anyone ever installed a Coram slimline shower tray bedded in tile adhesive or even sand and cement?

Below is a link to the instructions, for fitting the shower tray without riser legs onto a timber or solid floor but it only mentions using Silicon sealant to bed the shower tray.

[DLMURL]http://dev.coram.co.uk/wp-content/uploads/2013/07/00-71037-00-Slimline-Showertray.pdf[/DLMURL]

Thanks

 

[Qwerty]

I've used tile adhesive with no issues at all. Tend to use sticks like #*•t more

 

[Chalker]

SPF makes the tray nice and solid.

 

[Speedoman]

Thank you both for your replies!

Could I just ask please, in the link to the instructions, step 3 mentions putting Silicon sealant on the centre foot under the shower tray. Does this mean the centre foot is not removable?

Do you put the tile adhesive in only the places where the instructions tell you to put Silicon sealant or do you put the tile adhesive with a trowel covering the entire area of the plywood and then you bed the shower tray?

If covering the entire area of the plywood with tile adhesive, what size trowel do you use?

Many thanks for your help!

 

[Chalker]

Fitted a resin tray ( like yours) today. If your struggling for depth of adhesive. This is another way without using a notched trowel. Still solid bed.

 

[charlie1]

Just use a large (10 x 10 cm) blob of adhesive every 20 -30 cm. that holds it ok

 

[Speedoman]

Thank you everyone for your replies!

I decided I am going to buy the Mira flight low shower tray!