Montolit MasterPiuma P3 Series Comments Please

[Chris_32]

Hi everyone, thinking of getting myself a Montolit 75P3 and just wondered what peoples experiences with this cutter series have been. Been working with some troublesome tiles that the TS-60 just can't handle and a friend has recommended the montolit to me in the past. Any Input on this would be more than helpful, Thanks.

 

[gamma38]

Good cutters i reckon, I have two of them. I only use these and my family of sigma's nowadays. Sigma being by far the best but the monty's are a good cutter.

 

[Chris_32]

Do you think that i would be better off getting a sigma? If so could you explain why as I have no experience of using a sigma, only rubi, what makes it better than the Montolit? Also which model sigma is best?

 

[radim]

I had montolit but switched to sigma...
good cutters tho..

 

[Sean SML Tiling]

I had montolit but switched to sigma...
good cutters tho..

Same here. Had the 63cm cutter and yes it was far better than a rubi but not in the same league as a sigma. The monty I found to be a little brutal on times and can easily smash tiles to bits.

 

[Chris_32]

Sounds like I should go with the sigma. Any opinions on the best model?

 

[stephenoneill]

Dont listen to the conververts.montys are great better than sigmas. I started my career with a sigma and then discovered montys.Bring it on lads

 

[Stef]

Save your money & purchase a Sigma.
If your coming from a Rubi I would go for a max series, push cut.
Once you get the hang of the cutting action & lining up of the tile you will never look back.