Moving joints

[dhsanta65]

Potentially got a 42m2 floor to do hallway running into kitchen then into extension. Hallway and kitchen have a concrete base, extension is chipwood and sitting at a lower level so will over board to bring it up.
I assume I need some kind of moving joint were the two substrates meet, never used a moving joint before so was wondering about the setting out of the tiles, is it best to have a full tile either side of joint and if so how does this affect my setting out (if you know what I mean) ie for best cuts.

 

[CON5933]

set out from the joint, full tile either side and work back to the door, might take a bit of jigging around, but if you can see it from the entry point it wants to look like a natural flow into the room.. the joint could be filled with a similar coloured sealant to the grout..or if preferred, a manufactured movement joint.

 

[foxman]

Sometimes its not possible to set out either side of the two surfaces with your tiles might, not work out for best cuts, but as previously mentioned you must put a Silicon expansion joint where the two surfaces meet, then lay dural ci matting this will alow for any lateral movement, and tile over as normal.

 

[david campbell]

best as said to keep it looking as natural as possible,would opt for a mapei grout with matching Silicon if possible!