Porcelain Tiles

[LHowellCeramics]

Which cutter do you use for this? What does every one reconmend. Looking for a cutter more for this product.

Cheers

 

[Stewart]

I use a Rubi TX700 and you can't fault it.....

 

[Rich]

As above, the Rubi TX is a great cutter. It depends on what cuts you will be making, you could use a wet saw. This will cut cleaner than any manual cutter but will take a lot more time.

 

[Del W]

What size & thickness?

 

[Andy Allen]

nah.......get yourself a sigma......cut the most hardest porcelain you can throw at it (and it wont fall apart) :smilewinkgrin:

 

[Ian]

Rubi TX700 for me. Big clinker is a good porcelain cutter, but don't expect it to last more than 12 months.

 

[The Legend; Phil Hobson RIP]

Rubi TX 700 for me

 

[Deleted member 1779]

And if you need to DRILL it then this is your answer:

 

[Alan.P]

Depends on the size of the cuts and the porc tile but I cut them on anything from my Rubi TS50 up to Tx700

 

[CJ CERAMICS]

rubi tx 700 too for me

 

[Gall.B]

Sigma or Tomecanic Supercoup.

Sigma will last you all your days, still use on sometimes that is nearly older than me!

 

[LHowellCeramics]

Cheers. Just in general my ts50 plus is slowly falling apart want something abit stronger and meaner but cannot decide which way to go. Shall have a look into this

 

[Rich]

If you are used to Rubi I would suggest that you have a look at the TX, brilliant cutter that will last you forever if you look after it. If that is a bit pricey tho, might be worth looking at the TR, bit more grunt than the TS.

Have a look through the link below for a bit more info


Rubi Tile cutters...