flex

  1. G

    Radiator flex pipes Discussion Thread

    Radiator flex pipes Discussion Thread Could I pull these flex pipes up by cable tying them onto the back of the radiator (it’s a double rad) Just wondering if the heat against the cable ties would be ok. I’ve seen the cable clips you can get but not much room for them. Any help appreciated...
  2. S

    UK Flex or non-flex adhesive for sticking backer boards to masonry wall?

    Just wondered what would be best? The original tiles had a few hairline cracks from the house settling. I’m planning to use flexible to stick tiles to the backer board.
  3. L

    Weberfloor flex dry time

    Hi guys, I've just installed Weberfloor flex in a small area 1m2 @35-40mm depth in one pour. The data/spec states 24hr dry time @5mm only, and " can be built up to 50mm " drying times vary, conditions etc. So not quite clear on expected dry time at the depth I've installed it at. Could...
  4. Steve_Bcs

    Bal Rapid Flex One Vs Bal Rapid XP plus

    Whats the difference between these two Bal adhesives please, aside from price and the xp only being available from Topps. Job is 800x800 x 8 porcelain floor tiles, 50sqm onto an anti crack mat over slc on a concrete subfloor with low profile wet ufh. Tia
  5. D

    Self Levelling Compound Has Hairline Cracks After Walking Over It. 20mm Insulation?

    Hi everyone, Hope to get some help and advice please. I have laid down 8mm of self levelling compound on a concrete floor after priming it so it was a good level to work off (I also included an 8mm expansion joint around the perimeter) (Conservatory is 15 years old and area of 14 m2). I then...
  6. D

    hairline crack, slight flex in 2 tiles - to foam or not to foam?

    In short: would using some expanding foam behind 2 tiles that have a small amount of flex, where I presume adhesive has partially de-bonded help fill the void and re-glue the to tile to breeze block? Or inject some kind of adhesive/Silicon to where i can get to with grout removal? The long...
  7. N

    FREE 2 bags of Nicobond Large Format Flex Adhesive & Mixing Bucket

    FREE 2 bags of Nicobond Large Format Flex Adhesive & Mixing Bucket for all attendees that visit us at our Nicobond Technical Tiling Solutions Roadshow. Terms and conditions apply. Orders must be placed in person on the day, at the event location by the person attending the seminar. Orders will...
  8. B

    Rubi Flex CS60 or Rubi TC180 wanted

    anyone on here selling any of these saws and rails?
  9. Wishiwasatoptiler

    Flex cordless paddle mixer

    Hi Has any folk got this mixer, whats it like for mixing across the day and can mix plasters as well as tile addy. Cheers
  10. J

    BAL bal flex bone 2 easy

    hi all has any one used this decoupling mat by BAL yet. Was talking to there REP today and am thinking about using it on a job which is getting an anhydrite screed. there seam to be alot of advantages to using this product but need to know your views
  11. J

    BAL Bal rapid flex one vs ultra pro flex sp

    Any opinions on either of these? I’m used to tilemaster setaflex but my local tile shop has just taken on ultra instead. But I’ve been looking at the rapid flex one as well. Anything to take on board before testing either?
  12. O

    Ardex Ardex X 60 PUERTO Flex

    Anybody else had a letter like this recently?
  13. Del W

    Very impressed with Kerakoll Eco Flex

    As the title says. I mostley use Mapei but will be giving Kerakoll another few goes. It cleans off the face of tiles really well. :)
  14. B

    BAL BAL rapid flex 1 White

    New BAL rapid flex 1 white adhesive, used last week on a bathroom floor where needed to be back up and running by end of day as only toilet in house. On offer at CTD just now at a really good price it really was lovely stuff to work with, really creamy no lumps, very spreadable onto floor and...
  15. M

    Rubi Rubi TC180 or Flex CS60?

    My quest for an easier envelope cutting solution continues.... I mainly work with 60 x 60cm porcs so I need something that is up to the job and produces factory edge cuts I've got a Festool angle grinder system which runs on a track but the quality of cuts isn't good enough. Also, if you want...
  16. I

    Kerakoll bio flex s1

    still a novelty :( I do not like, too rubbery and hard-to-clean
  17. Ttt1601

    Tiled bar top

    I have a bit of an odd one, am doing a shop fit, client is having 100 x 100 ceramics on the bar top, bar has been constructed by 2 18mm who play sheets glued and screwed together, no apart from the obvious breakage issues, I am a bit unsure what products are best to use, was thinking of double...
  18. P

    Tiling Over Joists.

    Hello, we've just bought a new house, the current ground floor is concrete and I'm thinking about installing under-floor-heating. I don't want to screed as the reception room areas are too large, (16 2m each of 2) so I was thinking of putting down a DPM with 4x2 sawn battens (at 400mm...
  19. R

    BAL Bal Rapid Flex Fibre Plus Vs Ultimate

    I've quoted for a job 35 metres polished porcelain using TileMaster Ultimate onto a newly screeded Orangery. The customer has since come back saying Topps will give them a substantial discount on the tiles if they purchase the Bal adhesive in the title. Anyone out there used it? Is it any good...
  20. gamma38

    New Rail Saw

    As the title says, i'm going to invest in a rail saw and i was wondering how many people have them, how good they are etc?? It needs to be able to mitre as well, and be used wet or dry with reasonable dust extraction. Up to now i've only looked at the Flex CS60 and the Marcrist STC185. The Rubi...

Advertisement

Back
Top

Click Here to Register for Free / Remove Ad