Advice needed with dry cutter

[Ben Ross]

My brand new sigma 3c3m is not giving me a clean cut
I've compared it to a cut from my Rubi ts60
See attached photos 1st photo is Rubi cut second is sigma

Ceramic tile 450 x 350

What can be the problem?

 

[Blunt Tool]

Think you might be pressing too hard

 

[Ben Ross]

Think you might be pressing too hard

I tried it few times different pressures same result
il have a go again tomorrow when theres more day light

 

[Flintstone]

I think so too, very light score is all that's neeed most of the time with sigma, hold the handle further down on towards the bend see if that helps

 

[Flintstone]

Good old rubi has took the corner off, comes as standard that feature doesn't it ?😀

 

[Ben Ross]

Good old rubi has took the corner off, comes as standard that feature doesn't it ?😀

Ye i was gonna cut another then thought ach it will no matter haha
first time using sigma so must have been a bit to rough with it lol