Ats Diamond Tools

[Diamond Pool Finishers]

Just posted a little film to your Facebook page, it's simple to upload take a look, I'll ring soon and order some 125 pads look good! Only used that 50 bit course for our finish, we usually use 60s and done not sure if 100 would be too fine

 

[Concrete guy]

That looks very cold and very wet!

It might be worth having a #30 pad in your kit to sort out localised lumps and bumps quickly.

If these are simply used for smoothing the surface rather than creating an actual finish I'm not sure you'd need #100. The #30 and #50 would probably be just fine. You might want to try a semi rigid rubber backer to allow the pads to take on more of the shape of the curve, this will reduce the edge wear that you get in the image you posted above.

 

[Amir Patwa]

This is a picture of the pad, is this a flexible copper?

View attachment 77251

Usually cost £* Any grit 100(4")