O
One Day
It's the angle at which the blade hits the glaze.
Upside down on the Sigma, the angle is increased closer to 90 degrees slightly.
I've noticed the same on my DeWalt. Normally the blade is set as low as possible but some glazed porcelains seem to chip less with the blade set just enough to get through the tile.
Upside down on the Sigma, the angle is increased closer to 90 degrees slightly.
I've noticed the same on my DeWalt. Normally the blade is set as low as possible but some glazed porcelains seem to chip less with the blade set just enough to get through the tile.
