Door steps

[padtheplumber]

Norcros say there pro boards can be used outside Stef

 

[TJ Smiler]

I would use the AM100 mate it's a great product and probably a bit cheaper in the long run. Make yourself a frame for the step, ie: get 2 pieces of flat and straight timber sitting on top of your step one on each side of the step and slightly overhanging the riser, then screw two pieces of timber into the underside of the top two. You will now have two little frames with right angles at each side of the step, loose lay these over the step and pack them up or down so they are level (all this will only take about ten minutes) then fill the gap in the middle with a derby. It's pretty easy mate.

 

[TJ Smiler]

Sorry mate i didn't mean to sound patronising in my last post about it being easy, probably doesn't read the same as i intended it too sound :smiley2:

 

[Stef]

Not at all m8. I was going to do something along these lines any way, I was only trying to work out whether there were any boards available & see if it could be done. Cheers

 

[TJ Smiler]

Im sure there probably is and TBH i cant see why your idea of tanking hardi back and front wouldn't work.... apart from maybe the frost thing.

 

[TJ Smiler]

Make yourself a gauge out of timber, one piece that lays flat on the step the other at right angle to the angle of the riser..if you see what I mean.

Sorry mate, i didn't see this post when i left mine. Didn't mean to steel your glory