Hello and laser level advice please

[ishi69]

Cheers Phil. I'll make a few calls tomorrow could do with getting it sorted while I'm on hols.

 

[dave l and l]

calibrated .....is your pls not leveling properly?

 

[ishi69]

I've had it three yrs now and have noticed just recently that it's a little out. I noticed that if I swivelled it on the bracket thru 180 degrees the beam would drift of the marks I'd put on the wall. I think the pendulum inside needs adjusting.

 

[Perry]

Does anyone know where you can get the pls lasers calibrated ?

Laserplane - Suppliers of Survey & Confined Space Safety Equipment - Welcome to Laserplane

 

[dave l and l]

mine wasnt leveling right so i opened it up and a bit of grit had got in between the magnets so it was not leveling properly, cleaned it out with a bit of paper and it works again

 

[ishi69]

mine wasnt leveling right so i opened it up and a bit of grit had got in between the magnets so it was not leveling properly, cleaned it out with a bit of paper and it works again

Nice one Dave I'll try that first before sending it away.

 

[nybor62]

i have used both pls and dewalt, both very good lasers for accuracy i would opt for pls for durability dewalt imo

 

[Edb]

Cheers for the replies guys, much appreciated! I'll check out the recommendations and post my findings.
cheers again
ed

 

[Dannym80]

Hello to all!
I havent posted on here for quite a while, bit slack on my part I guess.
I just wanted to add a BIG THANKS for all the info on lasers, I've recently been looking into them & after reading this and a number of other related threads I think its got to be the PLS180 for me!