Nmp On Rough Floor

[Flintstone]

I'm doing a small bathroom and there is no more ply to go down, the floor has been previously tiled onto the floorboards so it's a bit up and down with patches of adhesive, I always use the mega glue and screws, wondering if using rapid flexi might be best option on this occasion? Anyone do that method with no more ply ?

 

[White Room]

I done very similar and used hardie with a deeper bed of adhesive and screwed.

 

[Flintstone]

Hardie isn't an option unfortunately.

 

[Rich Midge]

Smooth it out with an S2 or a flexible SLC then NMP when dry.

 

[White Room]

If you use a slc make sure theres no gaps/joints where it can disappear.

 

[Rich Midge]

If you use a slc make sure theres no gaps/joints where it can disappear.

Ha! A labourer for my brother in law's firm once used around 18 bags to smooth out a small hall "soz, it just kept falling through the gaps boss!" 2 short planks cannot begin to describe the guy.

 

[Spud]

But your self a grinder cup wheel and a dust extraction cowel that attaches straight into your Hoover , that old adhesive will be gone with in a hour and you can do the job like you normally do Pwm sales or Apex grange will have them in stock

 

[Flintstone]

Not gonna help me today, and I don't carry a Hoover! I can't really slc over the floor boards either as there are gaps between each one!

 

[J Sid]

you don't carry a hover

 

[Flintstone]

No I don't. Dust pan and brush for me.

I went for this option,