Porcelain External Angle

[bert7cosby]

Hi, I am currently tiling a bathroom with 600x 300 porcelain tiles and all is going well.
The sink area is a boxed section that protrudes from the back wall for the waste pipes etc.

As the tiles have a finished edge to them would It be acceptable to use butt joins on the external corner return ? this would mean that when facing the sink you would see one whole tile as the boxing is roughly 600mm and the edge of the return tiles on both sides .
Hope this makes sense ..or would it be better to use trims.
Thanks
Bert

 

[Spud]

Hi, I am currently tiling a bathroom with 600x 300 porcelain tiles and all is going well.
The sink area is a boxed section that protrudes from the back wall for the waste pipes etc.

As the tiles have a finished edge to them would It be acceptable to use butt joins on the external corner return ? this would mean that when facing the sink you would see one whole tile as the boxing is roughly 600mm and the edge of the return tiles on both sides .
Hope this makes sense ..or would it be better to use trims.
Thanks
Bert

you could mitre the tiles , but if they are the same colour all the way through then that is also fine , if they are polished porcelain you can polish the edges with wet and dry

 

[bert7cosby]

Thanks Gary, if I was to mitre the tile would it not leave a sharp edge on the cut side of the mitre ? Also can you give me a brief guide on polishing the raw edge as they are polished tiles
Thanks

 

[Old Mod]

Hi Bert and welcome to the forum.
If you could take 5 mins and start a new thread in the welcome forum giving a little information about yourself, not only would it be appreciated, but it will help members evaluate the level of advice to give you.

You can do this HERE
Just select new member prefix and away you go.

Thanks.