M
mattburlinson
Hi all,
Have been a member on this site for a little while and have used it for advice on a few occasions but never posted my own so here's my first, which happens to be a rant.
I was wondering if anyone may have had the problems that I have recently experienced with my Rubi 250 - N. Firstly the blade kept falling off despite increasingly tougher measures to tighten the reverse thread (no lockout like an angle grinder and only the blade to hold), cutting out when going through small victorian floor tiles and having a lot of movement when lifting motor and blade to align cut then realising it's about 3mm out when dropping it back down and starting to cut. I sent this machine back to the supplier and they replaced it instantly, well done HTW! But for the money these machines sell for i'm shocked at the refinement on many features - why don't they have start/stop button on the main handle for example?
Have been a member on this site for a little while and have used it for advice on a few occasions but never posted my own so here's my first, which happens to be a rant.
I was wondering if anyone may have had the problems that I have recently experienced with my Rubi 250 - N. Firstly the blade kept falling off despite increasingly tougher measures to tighten the reverse thread (no lockout like an angle grinder and only the blade to hold), cutting out when going through small victorian floor tiles and having a lot of movement when lifting motor and blade to align cut then realising it's about 3mm out when dropping it back down and starting to cut. I sent this machine back to the supplier and they replaced it instantly, well done HTW! But for the money these machines sell for i'm shocked at the refinement on many features - why don't they have start/stop button on the main handle for example?
