sigma or rubi table wet saws

[Diggy]

I'm a Rubi flat bed man , but when it comes to the wet cutters ,the 9M or 10M are miles better imho.

Diggy

 

[kaharrison9]

Blimey that's some feat!

I noticed Raimondi do a 1500 cutter think you'd need a moffitt to move that.

If ever stuck give for an overhead give us a call and have a blast on it.

 

[cam_low]

Selectively tbh. For marble and stone its amazing. But or 6x300 porcelain you have to cut from each end to stop it chipping. Whereas an overhead cutter you can line the tile up and away you go.

For cutting long tiles though its limited by what you can hold, I cut down a quartz top 2.5m long!

with my 9p I leave the cut approx 5mm at the end, pull it off and use the side of the blade to grind it flush to the edge. no need to flip it over which I do find irritating !

 

[gamma38]

I have just bought a rubi DC250, cut's 1200mm not even plugged it in yet, I will do a review on here when i have given it some stick.

 

[Chalker]

I have just bought a rubi DC250, cut's 1200mm not even plugged it in yet, I will do a review on here when i have given it some stick.

That's impressive.
It can cut, even though its not plugged in!

or is it punctuation?

 

[gamma38]

There is always one!!!! Usually me.

 

[Peter]

Sigma discontinued a bridge saw, the 10L. You can still pick them up for £7-800 and ten times the machine of the DW250 (have owned both).

Karl Dahm still sell the same saw branded differently.

 

[Peter]

www.karldahm.com/lshop,showdetail,1...,1109063017,39155,7,Tshowrub--1109063017,.htm

 

[kaharrison9]

Bit of a dark horse Karl Dahm

Sell some very good products