Ok so ive messed up a bit when tiling my shower room - after spending ages measuring tiles and where to start to avoid small cuts and getting the boarder in the right place, i placed a baton and tiled off that ive now tiled down to my shower tray and i am out by about 5mm - so rather than haveing a nice 3mm gap between the tray and my tiles to Silicon i am left with about 8mm - is this too big to fill ?
i can not raise the shower tray and short off taking all the tiles off and starting again i am not sure what to do
do you think 8mm is to big ? or should i look at some sort of edging trim / tile around the gap any advise greatly appreciated
i can not raise the shower tray and short off taking all the tiles off and starting again i am not sure what to do
do you think 8mm is to big ? or should i look at some sort of edging trim / tile around the gap any advise greatly appreciated
