Some advice on movement joints

[Customizer]

My kitchen/ dining room floor is as flat as the lake district!!! Im laying plywood and using self leveling compound to level the floor. Which means a movement joint must be used, Unless anyone out there knows a way so that a movement joint wont be needed?

Help!!!!!:sad_smile:

 

[DHTiling]

My kitchen/ dining room floor is as flat as the lake district!!! Im laying plywood and using self leveling compound to level the floor. Which means a movement joint must be used, Unless anyone out there knows a way so that a movement joint wont be needed?

Help!!!!!:sad_smile:

are the floors two different substrates, how long/wide is the room.

 

[Customizer]

can i send u an email with a picture and explanation of the floor?

 

[DHTiling]

ive sent u email details via pm

 

[Customizer]

Did u get the email, Can u understand it?

 

[DHTiling]

cheeers steve got it.
firstly,ply the timber floor using 15mm ply scewed down at 300mm intervals with twin thread screws prime edges abd back of ply with acrylic primer before fixing.
prime concrete floor, then selflevel floor ( i usaully use ardex k15 ) starting with the low spots and build from there until its flat . dont have to get it level as long as its flat.
where the boards meet the concrete put your movement joint there directly above the join between the two subtrates, either use a manufactured joint or form one your self with Silicon depending on what finish you want( same colour as grout ). Will look better if you start with full tiles from that point and work out from there.
HOPE THIS HELPS mate and good luck... dave...

 

[Customizer]

Thanks for the quick reply Dave

Is there any other way instead of using a movement joint?

 

[DHTiling]

not really because the subtrates expand at differant rates thus will cause your tiles
to debond if you dont put one in, if you use the Silicon method the joint will hardly be noticible. dave..

 

[Customizer]

Thanks for the advice...Cheers
----
Could you tell me where the best place to get self leveling compound from? I need to level to about 40mm in height..and 5 square mtr area?

 

[DHTiling]

i see you are in sunderland, so use c.t.d. and they stock ardex k15 which will go up to 50mm in one go by adding small grade chippings to it, full instructions on back of bag, i swear by it , it has a good flow rate and fast curing time ( light foot traffic 2 - 3 hrs and can be tiled on following day regardless of thickness. 1 bag does about 2sqr mtrs at about 6mm thick , costs around £20.00 for 22kg bag.

they are at brooke street sunderland also team valley/darlington/newcastle/stocton

 

[guy1976]

ctd is right next to the stadium of rubbish£ k15 is about £22 trade not sure retail price they will have to order the grannite chipping in for you as they dont keep them in stock there

 

[Varley]

ctd is right next to the stadium of rubbish£

Thats quite enough of that thankyou very much :wink_smile:
----
Just you wait till next season guy

 

[brian c]

use 5mm spacers as this reduces the noticeability of the Silicon movement joint.