Tilers spirit levels??

[Old Mod]

Just for you Andy @Localtiler,
There are some reflections because of shower glass and highly polished rad, but it'll give you an idea of how it works.
If you look carefully the main cross hairs follow the joint vertical and horizontal.
The weird image is the line going up and over ceiling, and the long shot down corridor, if you expand you'll see the vertical line in the door jamb.
So last placed in one location it covers all surfaces. No separate wall or floor laser.
And tbh if you buy good quality separate items, the multibeam is just a bit more than the two put together.

 

[Flintstone]

I might get one of them floor levels, see how I get on

 

[hmtiling]

Good times

 

[J Sid]

Good times View attachment 88499

how much?

 

[Italy]

Good times View attachment 88499

NO RECEIVER?

 

[hmtiling]

how much?

£450 ffx

 

[hmtiling]

NO RECEIVER?

Not at the minute antonio. Bought a new van and this in a week. Skint now!

 

[hmtiling]

after a quick charge and mess around the only negative(very slight) is it doesn't have a fine tune for vertical beam like my dw089k did. the positives are everything else!

 

[hmtiling]

after a quick charge and mess around the only negative(very slight) is it doesn't have a fine tune for vertical beam like my dw089k did. the positives are everything else!

to add to this it doesn't swivel super easily like the dw089k which makes fine adjustments easier

 

[J Sid]

after a quick charge and mess around the only negative(very slight) is it doesn't have a fine tune for vertical beam like my dw089k did. the positives are everything else!

to add to this it doesn't swivel super easily like the dw089k which makes fine adjustments easier

I won't be getting one then

 

[A williams]

I like the smooth stabilas . Easy to keep clean . Oh by the way buy a laser level

I was about to say the same thing!!!
Laser served me well - well uNess the battries die!!!

 

[J Sid]

so do any of these level manufactures make them with the bubble you can adjust to get it spot on after it starts reading wrong? They used to

 

[A williams]

I have a 10 inch bit holder for my drill that I do the same process but drivin screws into the floor so all the heads are the hight I want my slc pouring to

Great idea!!

 

[A williams]

&& everything is online if you look hard enough I'm sure you'll find one!!

Pendulum on the laser we use so it gets it right every time

 

[Benn Simmonds]

I got a good deal from Howdens. Stabila Type 70.2 120 and 60cm for around £50.