tiling into a corner

[AliGage]

I'd be more concerned on how i'm going to fix and seal the bath in after tiling the walls.

 

[AJH]

I'd be more concerned on how i'm going to fix and seal the bath in after tiling the walls.

the old bath was fitted and awkward as the corner is less than 90º, this time we've got a free standing bath

 

[AliGage]

Ahh so the bath in the picture is not the bath that's going in the room?

 

[Bakielita]

No comment. What do you think about the tiles?

Do you wanna know tru opinnion ? I can talk you , im make tiling 14 years , 10 years in London. Hugh mistake about calculation brick view , Corner batch litle cut - mistake , you shouldby start from corner bath full tiles/half tiles.
Another mistake is the big on the world , how is posible dont put tiles on the top of batch with 1-2mm gap, the wall with tiles is done first and after somebody pus bath up to the wall , LOL , Good luck with future leak ,
Definitely leak coming , the protection of leak ,is silicon now only , thats not good for 100%. Always tiles must be put on the top of batch , sink , worktop , floor ALWAYS!!!

 

[bugs183]

I think it looks fine as you've done it.
You have nice neat half/full tiles on the left which is the most obvious run of tiles (remember to sit where the loo is going, thats where your eyes look from), then you have nice cuts wrapping around the bath area. If you were fully tiling the wall you would approach it differently again, but i think it looks great as it is.
I was going to comment about the bath, but if you're going to have a free standing one then that solves that point.

 

[AJH]

Many thanks to all of you for your comments. It's nearly a week on now and I'm convinced that I did it the right way. I'm very happy, God bless all!

AJ

 

[AJH]

Well it's taken a while but I've almost finished tiling, the wife says that I've done the corner join wrong though. I have continued the tiles on one wall into the corner then cut the tiles on the other wall into them leaving a 2.5-3mm gap. She wants both tiles to stop short of the corner with a 3mm gap between. I've attached a photo of the tiled corner and a PDF. Opinions on which way is right please. thanks​

 

[Tony73]

1 is if you use tile trim
2 for mitred corners

 

[AJH]

so she's right then, but isn't it difficult to do? The RHS wall goes out v/slightly at the top as well. Would a trim look right?

 

[Tony73]

it is if you DIYer. If i was you i would go with no 1 and use tile trim.

 

[AliGage]

The trim will give you a couple of mil tolerance with your cuts into it anyway. But i think the work you've done looks fine.

 

[AJH]

thanks Ali, any particular tile trim that you would recommend?

 

[AliGage]

I haven't used corner trim in almost a decade fella to be honest. But as far as trim goes for a cheap enough price, you can't go wrong with homelux. Most DIY shops and DIY tile stores will sell it.