J
jimh20
Hi,
I'm tiling our bathroom (DIY), and got good advice about mosaic borders.
Now I'm trying to tile the plywood face of the shallow box which contains the pipes and cables for the over-the-bath shower. I sealed the ply with BAL SBR, and am using BAL Blue Star adhesive, for 333x250mm ceramic tiles.
A couple of the tiles have fallen off, although plenty of adhesive was used, and is still firmly attached to the ply. I'm intending to box in the bath with ply on a stout frame, and tile that. I'll need to bore a few holes through the tiles in these areas, so it's not looking good!
Am I doing something basically wrong here? The ply was tiled successfully for years, with little 4in x 4in tiles.
Thanks again for any advice. Regards, Jim
I'm tiling our bathroom (DIY), and got good advice about mosaic borders.
Now I'm trying to tile the plywood face of the shallow box which contains the pipes and cables for the over-the-bath shower. I sealed the ply with BAL SBR, and am using BAL Blue Star adhesive, for 333x250mm ceramic tiles.
A couple of the tiles have fallen off, although plenty of adhesive was used, and is still firmly attached to the ply. I'm intending to box in the bath with ply on a stout frame, and tile that. I'll need to bore a few holes through the tiles in these areas, so it's not looking good!
Am I doing something basically wrong here? The ply was tiled successfully for years, with little 4in x 4in tiles.
Thanks again for any advice. Regards, Jim