C
cja
Another day another question.. sorry!
Travertine, 12.5mm 610x406 on walls
Brick bonded pattern, need to go 'around' an alcove - it works out that visually it would look better to make the cut in a single tile, but i'm not sure if it's practical?
I've illustrated in a diagram, apologies for the pink - the picture on the left is how i think it would normally be done - 2 tiles, 2 cuts in each, polish the edges. However, on the right is how it would look better - 1 tile, 3 cuts - but i'm not sure what tool would be up to the job of making the horizontal cut? Any ideas?
Thanks!
Travertine, 12.5mm 610x406 on walls
Brick bonded pattern, need to go 'around' an alcove - it works out that visually it would look better to make the cut in a single tile, but i'm not sure if it's practical?
I've illustrated in a diagram, apologies for the pink - the picture on the left is how i think it would normally be done - 2 tiles, 2 cuts in each, polish the edges. However, on the right is how it would look better - 1 tile, 3 cuts - but i'm not sure what tool would be up to the job of making the horizontal cut? Any ideas?
Thanks!