Where mosaic meets 60x30 in wetroom

[James De]

morning,

So I’m tiling the floor today in the wetroom (yup, still on this job!).

The tray I’m doing in 10mm porcelain mosaic (4mm addy bed), the remainder in 10mm porcelain 60x30 (12mm addy bed).

The mosaic will sit lower. I need to raise it by 4mm so there isn’t a step, how would I do that?

Thanks in advance everyone

 

[Boggs]

Bed in some 4mm backer board, not sure you will get that at short notice though.

Topps tiles do stock mosaic self adhesive backers made by Beava I think, they are about 3mm thick, they also keep your mosaics in place nicely.

 

[Spare Tool]

Trowel a skim of rapidset around the edge of tray and feather down..

 

[Flintstone]

Personally I wouldn't feather as you will see it and find it hard to get that nice. I wouldn't use mosaic mesh on a wet tray either. 4mm backer board or you could use a 4mm trowel and carefully serate the tray with rapid set, leave it to set. Then skim in the gaps between the ridges, leave it to set and you have a 4mm solid bed to tile on. That's if time allows

 

[Waluigi]

I would’ve accommodated the difference during the installation of the wet Dec and adjoining floor.

 

[James De]

I would’ve accommodated the difference during the installation of the wet Dec and adjoining floor.

At the time of install she was using the same tiles for the entire floor, she changed her mind to mosaics last week

 

[Waluigi]

I would’ve said that you’ve allowed for the same tiles. She can’t just change her mind. I’d put the pressure on the customer to revert back to the original plan.

All these ideas to overcome the problem are a bit of a compromise. I’d put the onus on the customer that it creates a problem.

 

[jasper]

I would’ve said that you’ve allowed for the same tiles. She can’t just change her mind. I’d put the pressure on the customer to revert back to the original plan.

All these ideas to overcome the problem are a bit of a compromise. I’d put the onus on the customer that it creates a problem.

Blimey - remind me not to get you on site. Sometimes people change their mind - I mean its not like they are paying you to provide a service is it?

 

[Blunt Tool]

Blimey - remind me not to get you on site. Sometimes people change their mind - I mean its not like they are paying you to provide a service is it?

Agree, now a proper tiler would just smile and over come the problem it causes with ease but these plumber types

 

[Waluigi]

Ahhh that’s better

 

[Blunt Tool]

Yes it is

 

[Waluigi]

Blimey - remind me not to get you on site. Sometimes people change their mind - I mean its not like they are paying you to provide a service is it?

If they weren’t paying me, I wouldn’t be doing the work full stop

 

[Simon Dale]

I would’ve said that you’ve allowed for the same tiles. She can’t just change her mind. I’d put the pressure on the customer to revert back to the original plan.

All these ideas to overcome the problem are a bit of a compromise. I’d put the onus on the customer that it creates a problem.

We as tilers should get over these minor mishaps

 

[Waluigi]

I’ve requested the removal of the title on two occasions now .........this is the third.

I’m going for a no deal Wexit

 

[Blunt Tool]

I’ve requested the removal of the title on two occasions now .........this is the third.

I’m going for a no deal Wexit

You can’t you’ve grown on us, it’s like the mafia once you’re in there’s only one way out!