Electrical Advice

Vitesse plus Discussion ThreadVitesse plus Electrical Advice

We have some very old delmatic lighting control modules that have pcb and relays for switching they have mostly burnt out. I need to change them for a modern control, I was thinking vitesse plus bit would the no volt switching work with this or should I just use a pir? Cp electronics want to charge £500 a day for a site visit. I could upgrade these myself but wondered if anyone has advice or a better solution? This is a...

 

Sub Mains to a Load Centre in a Domestic Dwelling Discussion ThreadSub Mains to a Load Centre in a Domestic Dwelling Electrical Advice

I am a retired electrician doing a home rewire.

I'm taking my time because I fell about 3m off a ladder & put both bones through the inside of my right leg.
That has slowed things down a lot...

My understanding of the AS:3000 regs is that all circuits in a domestic residence must be RCD protected.


When we moved here I replaced the tiny & cramped...

 

Adding Powerchair accessories Discussion ThreadAdding Powerchair accessories Electrical Advice

I have been requested to install an audible horn and an amber beacon light on a Powerchair to comply with road regulations. Although the task seems straightforward, I am uncertain about the legal implications of performing this modification.

Adding Powerchair accessories for the original thread on Electricians Forums

 

How to identify presence of an earth electrode Discussion ThreadHow to identify presence of an earth electrode Electrical Advice

Hello to all you fine folk out there.

I have a question regarding earth electrodes.

I've had two periodic inspections/EICRS recently, where I haven't been able to locate the earth electrode. I am guessing they are installed but have possibly been covered over by new patio extensions and other ground works. The reason I say this is that in both cases, they...

 

Need to post so thought I would introduce myself. Discussion ThreadNeed to post so thought I would introduce myself. Electrical Advice

Was a member for years on here, I'm 60 now and recently changed jobs! Due to a buy out of the company I'd been with for 18 years.
Lost my log in there didn't have it saved anywhere or access to my old emails!
So here I am again!
NICEIC QS for the company I'm with. Not properly been on the kit for 20 years!

Need to post so thought I would...

 

I have a DC-INT (DC interference) fault Discussion ThreadI have a DC-INT (DC interference) fault Electrical Advice

I have a recurring DC Interference fault on my solar system. I have gone through all the scenarios recommended by Solis, but still no solution. All I can pinpoint is that the fault occurs when the batteries have just equalised at 100% and there is an additional power demand such as switching on a kettle or washing machine. Any advice as to what I can look for? The...

 

Moving cables and sockets/switches over insulation Discussion ThreadMoving cables and sockets/switches over insulation Electrical Advice

Hi,
I'm about to reroute cables and sockets/switches from the ceiling down to the socket height after insulating a wall.
I understand this will derate the cable, so what it the best way to do this please?

EDIT: Should be in DIY
Camerart

Moving cables and sockets/switches over insulation for the original thread on Electricians Forums

 

individual RCBOs or a main breaker RCBO? and what trip level 10mA or 30mA Discussion Threadindividual RCBOs or a main breaker RCBO? and what trip level 10mA or 30mA Electrical Advice

I have the feeling that I might have small currents running in the house. So first of all, I am considering to get a leakage clamp meter. But besides of this, I am also considering to replace the breakers with RCBO. But then the question, should I go for indivdual rcbo or just replace the main breaker...

 

Hi,New member just saying hello as being nagged by email, Discussion ThreadHi,New member just saying hello as being nagged by email, Electrical Advice

Hello to everone on the forum

Been in the trade some 45 years now and Contracting on our own since 1990. Wouldn't change a thing Lol. Now doing EICR'S on properties we wired in the early 90,s. Absolutely love spending these lovely weekends in the office doing paperwork and chasing around all the time.LOL. Newbuilds are our speciality...

 

Does anyone have NVQ level 3 portfolio samples or any guide in relation to that? Discussion ThreadDoes anyone have NVQ level 3 portfolio samples or any guide in relation to that? Electrical Advice

Can anyone help me with this?

Does anyone have NVQ level 3 portfolio samples or any guide in relation to that? for the original thread on Electricians Forums

 

SolarEdge backup interface issue Discussion ThreadSolarEdge backup interface issue Electrical Advice

Anyone had a SolarEdge backup interface that does not power the property during powercut?
The battery is fully charged, you can hear the contactor switching over, leds confirm that it's in backup mode, but house has no power...

SolarEdge backup interface issue for the original thread on Electricians Forums

 

Revox A77 does not record with front Jack. Problem? Discussion ThreadRevox A77 does not record with front Jack. Problem? Electrical Advice

After his restauration everything was ok! But he does not record with the Jack in the front.

Revox A77 does not record with front Jack. Problem? for the original thread on Electricians Forums

 

FIKE fire panel key Discussion ThreadFIKE fire panel key Electrical Advice

https://www.amazon.co.uk/Fike-Rafiki-Twinflex-09-0026-Panel/dp/B01BKQCR7Q/ref=rvi_d_sccl_6/259-6940442-6992409?pd_rd_w=1mkG1&content-id=amzn1.sym.d56e60fb-87bc-405a-a95d-c5e322a9b3d9&pf_rd_p=d56e60fb-87bc-405a-a95d-c5e322a9b3d9&pf_rd_r=GZ66J3Q9SJETMVN0EQ56&pd_rd_wg=eKQhp&pd_rd_r=5b8f6ffd-6ec8-4227-b413-4ac79e958510&pd_rd_i=B01BKQCR7Q&psc=1

Bought this FIKE panel key for user mode weekly fire safety...

 

Revox A77, doesn’t record, Jack in the front Discussion ThreadRevox A77, doesn’t record, Jack in the front Electrical Advice

I have a bandrecorder Revox A77 case model with speakers and amplification. Model MK4 from 1977. He had a total restauration and after everything was ok except that he would’t record with the Jack in the front. What could be wrong?

Revox A77, doesn’t record, Jack in the front for the original thread on Electricians Forums

 

Can we reduce voltage on an electric fence? Discussion ThreadCan we reduce voltage on an electric fence? Electrical Advice

Just set up an electric fence system that outputs around 9KV and 10 Joules. I am worried about my pets and other live stock that the shock is too much. I wanted to know if we can reduce voltage of an electric fence.

Can we reduce voltage on an electric fence? for the original thread on Electricians Forums

 

What's the most badly designed accessory you've had to install? Discussion ThreadWhat's the most badly designed accessory you've had to install? Electrical Advice

What's the most badly designed accessory you've had to install?

I present my nomination, the ML Accessories/Knightsbridge RWL5 wall-mounted LED guide light

This nice-looking wall light has a low profile, is IP54 rated, and looks quite neat in "anthracite" colour. It's also about the right shape and size to cover...

 

They made me do it! Discussion ThreadThey made me do it! Electrical Advice

They made me do it!

They made me do it! for the original thread on Electricians Forums

 

Hello everyone Discussion ThreadHello everyone Electrical Advice

Hello to all members

Hello everyone for the original thread on Electricians Forums

 

Just saying Hi Discussion ThreadJust saying Hi Electrical Advice

They made me do it 🤷🏻‍♂️

Just saying Hi for the original thread on Electricians Forums

 

starting electrical improvers role 4 years after completing level 3 Discussion Threadstarting electrical improvers role 4 years after completing level 3 Electrical Advice

I’ve recently been offered a role as an electrical improver doing commercial and industrial work and I start in 2 weeks. The employer is aware that I’m going to be quite rusty as it’s been such a long time since I left college but I don’t want to go into this unprepared. I’ve been flicking through old course work...