Recent content by Mark@Tilemaster

  1. M

    Bal or tilemaster ??quartz

    Tilemaster Adhesives have been using Ultimate for around 10 years for installing quartz tiles, and to our knowledge have never had a failure. We have seen failures, be it an adhesive other than Ultimate used to stick the tiles, screeds that are still too wet to tile and poor workmanship among...
  2. M

    Bal or tilemaster ??quartz

    Afternoon, The answer to your question is yes - we will guarantee that the quartz tile won't curl when using Ultimate. As you have rightly said, there are so many variations of product out there and different factors that can cause an issue with the tile, but using Tilemaster Ultimate alone...
  3. M

    Bal or tilemaster ??quartz

    Hi Chris, Tilemaster Ultimate would be a suitable adhesive for your intended installation. Tilemaster Ultimate is suitable for installing quartz tiles due to it's polymer content and its low water content. As other members have mentioned previously, the S2 properties aren't needed in your...
  4. M

    2 new Adhesives from tile master

    Hi Andy, We already have one... Thick Bed FlexiRapid Adhesive | Tilemaster Adhesives - http://www.tilemasteradhesives.co.uk/adhesives/thick-bed-flexi-rapid-flexible-tile-adhesive But keep guessing guys...
  5. M

    BAL Bal GT1 Admixture..........

    Hi Andy, I realize this may arrive too late, however using BAL GT1 with Grout 3000 would be OK. For obvious reasons we'd prefer Flexmaster to be used, but where it is needed, GT1 will be suitable. I don't believe GT1 to be a PVA, although it is a form of enhanced liquid polymer that will...
  6. M

    Anhyfix fail on ditra matting

    Hi everyone. I have only just seen this thread so my apologies for the delay in replying. Firstly, I would just like to say that Anhyfix has been around for several years, in that time we have installed hundreds of m2 worth of tiles successfully onto anhydrite screeds, many of them installing an...
  7. M

    Best Tile Adhesive for Walls - 2016 Tile Adhesives Poll

    Hi Andy, if you want to message me with your details we will contact you on Monday with information of stockists for you
  8. M

    Best Tile Adhesive for Walls - 2016 Tile Adhesives Poll

    Dan - i'm sorry to hear about the "fake votes" and sincere apologies for our part in this. We had asked our 3 sales reps in the ceramic industry to make their customers aware of the tile adhesive poll. Our intention wasn't to get new forum users signing up just in order to cast a vote, our...
  9. M

    S2 adhesive & membrane required?

    There appears to be some conflict of interest here. As a tile adhesive manufacturer, we will always advise the correct product from our range to suit the application needs. As some members here have already pointed out above, Schluter do not advise an S2 adhesive being used either to adhere, or...
  10. M

    Tanking

    Afternoon All, In reality, there is no right or wrong way with regards to where in the process of building up the layers a tanking solution can be applied. We would normally advise to tank first, being that the substrates are tanked prior to a tiling installation being installed over the top...
  11. M

    What grout for wetroom floors? discuss!

    Let me check this one with the team Bob and I will come back to you.
  12. M

    What grout for wetroom floors? discuss!

    We actually advise a minimum of 3 days so by allowing 1 week you are well covered.
  13. M

    What grout for wetroom floors? discuss!

    1 week should be than sufficient.
  14. M

    What grout for wetroom floors? discuss!

    Evening Gents, Grout 3000 is softer than some grouts, mainly those that are based on a sand/cement type formulation. We have looked into this in great detail, as well as having the Grout 3000 tested as part of the EN13888 standards. The Grout 3000 is officially classed as abrasive resistant, i...
  15. M

    Tilemaster Ditra And Anhyfix

    Thank you for the posts and advice in helping out F430 and his questions. We have spoken this morning and hopefully we have put his concerns at rest. AnhyFix has been in production now for approximately 6 years so you can imagine how much has been used to fix different types of uncoupling...

Advertisement

Back