hole

I just bought some diamond drills and they work a treat

The wash basin has been relocated and has left a large hole in the brick wall. The whole area to be filled is about half a square metre with the deepest part in the middle about 2 inches deep. I've only just started as a tiler and not sure if / how to tackle this. I was thinking of building...

Anyone tell me which porcelain hole cutters they use, I am after a new set. Many on the market now - Rubi, 365, Armeg PTC and many more. Which are the best performers for the money. Know Armeg are one of the best but very expensive !!! :huh2:

hi new tiler here could anybody advice me on a decent set of hole cutters had no problem with wall tiles but needed to drill through floor tiles the other day and had a tough time cheers steve

I want to invest in the macrist diamond hole cutting system,could anyone advise me on how good it is?thanks

Any one used one of these they look a handy tool to have . http://www.rubi.com/ing/club/imagenes/fu1_3a.jpg

Hi Just need a bit of advice on a job I may be doing that I had a look at today. It was to replace some lower tiles in a shower unit but its not as simple as that. After the shower drain pipe leaked water had got into the substrate causing tiles to eventually come off. Anyway the client...

Can I tile on top of these areas> (sorry about the poor quality pics, they were taken on my mobile phone)

Just bought some of the 356 diamond drills for drilling through the harder stuff,but need some recommendations for drilling wall tiles, been looking at the RUBI carbide set on trade tiler, are they worth the cash, or are there any others worth taking a look at, Cheers.

Sometimes when drilling a hole you find it is too tight for a fitting to pass through. This could be a disaster if the tile has already been fitted on the wall. This rescue is not pretty but it will get you out of trouble in certain situations. Conventional drilling with a pilot...

What do you use for whole cutting in tiles?