Hi,
I'm not sure this is the right area for this post but hopefully someone can give me good advice. I have been recommended to use a Marmox type waterproof cementatious backer board to build up to the required height (20mm) of my concrete floor in the living room. My final floor surface is...
Threeskins
Thread
backerboard
marmoxmarmox backerboard
tile backerboard
usa
I am looking at boxing in a load of pipework and wondered if anybody has used this before? If so was it easy to use or can you suggest an alternative please?
Thanks
Geoff
Qwerty
Thread
backer board
backerboard
board
marmoxmarmox backerboard
tile
tile backerboard
usa
used
hi all.....
just want to confirm my research.....cost aside, is it true to say that the advantage of MARMOX backer board over hardibacker is that Marmox is both waterproof AND insulating whereas hardibacker is just waterproof?
Brad
Thread
backerboard
hardibacker
marmoxmarmox backerboard
tile backerboard
usa
I'm installing UFH. Current scenario:
- 9mm WPB Ply screwed down @ 150mm centres onto wooden floorboards
- 10mm Marmox insulation boards (1250 x 600mm)
- UFH cable
- Tiles
Question is for installation of the Marmox onto the ply. Would you use tiling adhesive (Granfix flexible rapidset 3mm...
TilingVirgin
Thread
backerboard
installation
marmoxmarmox backerboard
tile backerboard
usa
Dave I'm hoping you can help me out again since you have used similar. The plastic washers for these boards.. they are not marmox ones but just bog standard white plastic backerboard washers. They sit on the surface of the board when screwed in tight. Is this correct ie they don't have to sit...
sibs
Thread
backerboard
boards
marmoxmarmox backerboard
tile backerboard
usa
Hi all
Just taken delivery of some Marmox backer boards. I was really surprised by how light these boards are considering they take 62kg per sqm. They have foam middle and are mesh & cement on the outside.
Has anyone else worked with these? It doesn't seem possible that something so light can...
sibs
Thread
backerboard
boards
marmoxmarmox backerboard
tile backerboard
usa
Question from a DIY'er.
I've just layed a whole load of 10mm Marmox boards. The floor ws levelled first using slc and the boards were set into a flexible adhesive. The problem is the boards were all quite bowed, probably curved up to 3mm from the middle to the edge across the short edge. I...
Andy R
Thread
backerboard
marmoxmarmox backerboard
problem
tile backerboard
usa
Hiya,
I've had some Marmox 20mm insulation boards laid down on my conservatory floor today using Bal PTB Flexible adhesive, as I'm planning on installing some under tile heating also.
The boards were laid down by a guy who does tiling, so I left it in his hands, however on checking the boards...