problem

  1. Lou

    Turn signal problem Electrical Advice

    Turn signal problem Discussion ThreadTurn signal problem Electrical Advice My car a highly modified 1951 Studebaker, which was professionally wired (but with some issues I had to fix) now has a problem with the turn indicators. They had been working normally until recently. Now they work just...
  2. B

    Boiler problem Discussion Thread

    Boiler problem Discussion Thread I have a condensing boiler in my kitchen and every time I pour waste water down the sink there’s a gurgling noise at the boiler. I do know that the overflow from the boiler runs into my soil pipe and I have checked both waste pipe work and outside soil pipe work...
    • Belxvs
    • Thread
    • problem thread
    • Replies: 0
    • Forum: Plumbing Advice
  3. Lou

    Insulation resistance problem Electrical Advice

    Insulation resistance problem Discussion ThreadInsulation resistance problem Electrical Advice Hi all, Stuck on another job here IR testing. It's a simple 3 bed semi and after short put L-N at board and testing to earth, I'm getting 0.16 Mohms. I've disconnected main incoming neutral, no...
  4. L

    Underground oil tank feed problem Discussion Thread

    Underground oil tank feed problem Discussion Thread This unit is located in France where they use diesel not kerosene. The feed from the underground tank is not getting through to the boiler. The boiler works fine if I connect the hoses up to a remote tank of diesel. I am assuming that a filter...
    • LostinFrance
    • Thread
    • problem tank thread
    • Replies: 0
    • Forum: Plumbing Advice
  5. P

    water pressure problem, unvented system Discussion Thread

    water pressure problem, unvented system Discussion Thread I'm trying to sort out a problem with low water pressure at my elderly parent's house where they have an unvented system. I got a plumber in about a month ago who repressurised the system, after which it seemed better. However there...
    • plomero
    • Thread
    • problem system thread water
    • Replies: 0
    • Forum: Plumbing Advice
  6. S

    Shower screen reinsert problem Discussion Thread

    Shower screen reinsert problem Discussion Thread Hi I had to remove the glass panels from this quadrant shower cubicle and I'm struggling to get one of the screens back in place properly. The small glass panel is supposed to slide into the wall channel, and some holes in the side of the...
    • Sandy283
    • Thread
    • problem screen shower thread
    • Replies: 0
    • Forum: Plumbing Advice
  7. Lou

    Problem with Danfoss FP715Si Programmer Electrical Advice

    Problem with Danfoss FP715Si Programmer Discussion ThreadProblem with Danfoss FP715Si Programmer Electrical Advice Re: Danfoss FP715Si Programmer Anyone have any direct experience with this unit? NB: There are quite a lot of posts online about this issue, but nothing I have found that has...
  8. D

    Ideal Standard Dual Flush Cistern Overflow Problem Discussion Thread

    Ideal Standard Dual Flush Cistern Overflow Problem Discussion Thread Any help greatly appreciated. It appears that every time i flush the toilet the cistern fills up then overflows back in to the toilet. This can last for 2 minutes or is continually running. I have replaced the cistern dual...
    • damobolton
    • Thread
    • flush problem thread
    • Replies: 0
    • Forum: Plumbing Advice
  9. H

    Worcester greenstar combi problem Discussion Thread

    Worcester greenstar combi problem Discussion Thread Hi this is my first post so please be gentle. I have a Worcester greenstar 28i junior combi fitted in my house, we were having a troublesome drip from the back right of boiler, we found a gas safe plumber who come round and had a good look, he...
    • Happyharry
    • Thread
    • problem thread
    • Replies: 0
    • Forum: Plumbing Advice
  10. H

    Combi boiler problem Discussion Thread

    Combi boiler problem Discussion Thread Hi this is my first post so please be gentle. I have a Worcester greenstar 28i junior combi fitted in my house, we were having a troublesome drip from the back right of boiler, we found a gas safe plumber who come round and had a good look, he told me the...
    • Happyharry
    • Thread
    • problem thread
    • Replies: 0
    • Forum: Plumbing Advice
  11. Lou

    Revox A77 does not record with front Jack. Problem? Electrical Advice

    Revox A77 does not record with front Jack. Problem? Discussion ThreadRevox A77 does not record with front Jack. Problem? Electrical Advice After his restauration everything was ok! But he does not record with the Jack in the front. Revox A77 does not record with front Jack. Problem? for the...
  12. N

    Tiling problem with levels

    Hi all, would like some advice. I'm currently tiling an ensuite. I'm using 60 x 30 tiles. I have tiled the floor 1st on this occasion. I came straight off the floor with a full tile and now on the last wall but floor must be 20mm out so now will have to put a slither in at bottom. Not sure I...
  13. B

    Tile/Adhesive/Plaster Problem

    I started removing the tiles in my bathroom today and the majority of the plaster has come off the wall around the shower/bath area (see picture 1 & 2). No matter how carefully I tried to remove each tile either the tile came away and left the adhesive behind, or it all came off with the...
  14. S

    Drywall adhesive problem

    How do you remove this adhesive from floor tiles
  15. J

    Self leveling problem

    Hi all. I don’t really post, I get all my info usually from just searching. I have just attempted to self level my living room and hall way. I’m just after advice as it’s hasn’t exactly “ gone well “ I used mapei 3240. Mix to what the bag said. Left it couples minutes. Remixed. I poured it...
  16. M

    Slope problem in installed shower

    Looks like I didn't get the slope correct on this shower bed. Here's water not drained after 10 hours since turning off the shower. How atrocious is my fix going to have to be? Be honest. I can handle it.
  17. Barbara1

    Flooring problem needing help

    Morning everyone. Just ripped out the bathroom in bungalow, and are going to place Hardybackers on the wall as Iam using large wall tiles. The problem is the floor, where I’ve taken up the old tiles it’s taken up some of the concrete floor. Some of the void’s are 10mm others 3mm. What you...
  18. Has567

    Why are my new tiles bowing out and cracking? Please help!

    My newly tiled bathroom wall has presented a few issues in the last few days. Some of the tiles appear to be popping off with cracked grout lines and where this has occurred there is some bowing of the wall. I also have a tile in the bottom left corner that has cracked down the surface. This is...
  19. sbsmithjax

    Incredibly Perplexing Shower Tile Problem

    Greetings All, appreciate the expertise existing in this forum. I am a home remodeler, not a professional, but have done 4 homes completely down to the studs, including many many square feet of tiling floors, wall, ceiling, bathroom. I have a very difficult problem to diagnose. I have a...
  20. S

    Problem with LVT job

    So I ordered LVT from Luxury flooring. 2.5mm nest stick down. Had a tiler who did a great job at families house in ceramic tile. It seems he’s not so skilled in LVT. Where the kitchen kick boards are the lvt is gappy. There’s 5-10mm gaps. It’s IKEA kitchen so the kickboards are deeply set back...

Featured Threads

Advertisement

Tilers Forums UK | UK Tiling Forum
https://uktilingforum.co.uk | UK Tiling Forum
Back