room

  1. P

    New member looking for wet room installation advice.

    Hi Guys, I'm an old boy, new to this forum & still learning on the job after 17 yrs! Good or bad time will tell,looks like I have just bought the same wet tray former kit as the man in the 'tiler made a mistake tiling a wetroom tray' thread(see pic) Gunned up the screed & oversight & plonked it...
  2. H

    Wet Room: Kudos Aqua4ma Linear Installer reqd - experience necessary.

    Looking for an experienced installer for the Kudos Aqua4ma Linear system to fit if possible in a small bathroom of a flat in Hove.
  3. Ttt1601

    Marble wet room advise

    Hello gents I've got to price for a wetroom, never done one in marble before so just want to check a few things, what tanking system would you recommend? It's 50mm marble mosaics on the floor, with ufh and into the shower tray, then mosaic carrying up the wall 1000mm height, ceramic listello...
  4. O

    Bathroom/Wet room ex Garage

    Hi Guys Well after many months my new bathroom/wet room has tiles on the walls to almost the floor and looking pretty good. I purchased a tanking kit as the floor is concrete and was going to make as plinth and to tile on as I needed to get the fall right for the drainage which was about 3ft...
  5. J

    wet room shower base former recommendations

    ok plumbers (heating engineers) or fellow tilers a question. what pre formed wet deck would you recommend to go in a wet room with wet ufh that will not reduce the heat compared to the rest of the room which will have 18mm ply on it? Will be tiled
  6. J

    Wet Room remedial Job!!!!!!

    Where to start with this one? Been asked to remedy an upstairs wet room which is leaking after 5 years install. 30 x 30cm porcelain floor tiles. One starting to rock on one axis. The underfloor heating has been laid across the floor and up into the raised area for the shower. No grouting between...
  7. Chalker

    Making wet room tray from construction board

    as the title suggests. I gave 5 wet room trays to do. 3 are 1700 x 800mm and 2 are 2m x 1.8m! They are all on the first floor and are on solid ( block and beam ) floor. The sections for the trays has been formed and the rooms are screeded. The gaps for the trays are unscreeded with 50mm...
  8. J

    wet room shower trays

    just asking you guys which wet room trays do you prefer and which dont you rate. and why?
  9. M

    Tiling in a room with suspended and concrete floor, with under floor heating

    Hi. We are tiling a ground floor kitchen that is half suspended floor (100x50 joists on 300 spacing, with supports every 1200mm) and half concrete slab. The concrete slab has just been poured and once insulation has been added, it will have UFH pipes buried in the screed top layer. The tiles to...
  10. M

    Steam room-Bisazza 10mm graduated blend

    This is a steam room I finished last week and was good fun, small but a tad complicated. The customer had seen a pic of graduated mosaics and took it to Domus and they suggested Bisazza 10mm paperfaced mosaics, bless em lol. With the amount there was there wasnt enough for a vertical blend. With...
  11. A

    Wet room cuts

    Just wondering how you do your cuts in the slope into drain. Do you cut with your sigma or wet saw. Im thinking if cut with a sigma, you aren't going to get the 4mm joint one needs in a floor however I might be wrong. Also, when setting out your tiles. Do you make sure your grout line is...
  12. F

    Marble wet room

    Thought I would share a few photos from my latest offering, marble en suite, with bespoke hand made furniture. Still a couple of small finishing details to be finished
  13. U

    Wet room former

    tiled a wet room former today ,but bad design ,the channell water runway was to deep about 25 mm off addy did it but far to much ,anyone had this
  14. M

    How best to Tile a room?

    Hi All, I've just had an extension done and I'm wondering how best to tile the room, I am a novice and haven't tiled before, as if that wasn't hard enough, I am also fitting underfloor heating and dealing with 800mm by 800mm floor tiles. From the attached picture I am looking to tile the red...
  15. C

    Tilers needed for new build 60 room Hotel in Ealing

    Hi We need 2 x tilers for a new build hotel in Ealing, London starting asap. All bathrooms are fully tiled as well as around 350m2 to the reception and back of house areas. Must have CSCS cards. Please get in touch for more info Thanks Craig
  16. J

    Wet room fun

    Hi Guys, Is there anybody had fun with wet room like this? Just wondering if anybody was able successfully remove this underlay? Changing the floor is not an option due sink unit and toilet have the same furniture. Also to find the screws to unscrew the floor is less likely than a lottery...
  17. M

    Kudos aqua former wet room system

    Great system for wet rooms. sort of tongue and grooved water tight wall panels. shower trays has built in falls and tiling cut lines pre marked for envelopes etc. Would recomend this system to anyone who still messes around with marmox and the likes and in my opinion is much better than a thin...
  18. F

    The Best Wet Room Tray

    Following on from that terrible tray I posted a pic of, can some one advise on the best tray with adjustable height waste and floor level water run off. ? I can ensure its used in future by that contact.
  19. G

    Setting Out Where To Start In A Square Room?

    Hi I am new to tiling and looking to start a 5m x 5m floor. I know I should be finding the centre and taking lines out from here but where is best to start as if I start from the middle and work my way out to the far wall I am not going to be able to reach over the tiles I have laid?? Sorry...
  20. J

    Wet Room Channels

    Can you use bal rapid addi to tile direct onto (s/s) wet room drain channel insert ? Cheers

Advertisement

Top