shower

  1. R

    Shower former advice

    Hi everyone, new member here looking for some advice. I’m looking for a shower former for a loft conversion wetroom. It has to sit on joists, has a width restriction of 800mm, and needs an off-centre drain. There is a girder running beneath that would obstruct a centre drain. I was looking at...
  2. M

    "Freestanding" shower bath

    Hi all, brand new here so be gentle!! We've just bought a new place that needs a full refurb - needs heating installing and rewire etc. In the meantime i'm planning the bathroom to distract myself from the horrors that lay ahead. The plan is to have a free standing shower bath (flat to the...
  3. T

    Pebble Shower - Grout Selection

    Hi, I've installed a flat pebble shower floor over a Schluter foam pan. It looks nice. I need help with grout selection since these flat rocks don't drain as well as some flat tiles. It seems that Mapei Ultra Pro FA grout can handle joints up to 3/4". There are many grouts that can't and I...
  4. M

    Silicon Gap around shower tray

    Ok so ive messed up a bit when tiling my shower room - after spending ages measuring tiles and where to start to avoid small cuts and getting the boarder in the right place, i placed a baton and tiled off that ive now tiled down to my shower tray and i am out by about 5mm - so rather than...
  5. S

    'retro-tanking' shower?

    I've a shower to repair where on one wall the lower half of the existing tiles are loose and the plasterboard behind deteriorated. When I remove the tiles and damaged board, what is the best approach? Cement backer board I guess, but how to waterproof effectively where 2 sides of the existing...
  6. R

    Shower tray / tile gap

    Hi, I have just tiled my bathroom wall and done the last row around the shower tray. I wasn’t sure how much gap to leave but it ranges between 4mm and 5mm. I have tanked the walls and used the Mapei tape also around the shower tray. Are those size gaps ok? Looks like sealant would fill them...
  7. R

    Tiling on top of shower tray with tanking

    I’ve tanked a the bathroom walls with Mapei showerproofing kit and I’ve installed a shower tray. The walls are all tiled now and I am going to do the last row in on top of the shower tray. My question is because Mapei recommend putting the tape along the shower tray and wall and tanking over...
  8. B

    Steam-Shower Pan Materials & Techniques

    Hello All, My name is Daniel and I'm brand new to this forum. I'm looking for advice and suggestions on how to properly construct a steam shower pan. What techniques, and more importantly, what materials do folks use for these? Is PVC/Chloraloy membrane a no-no? Which membrane materials can...
  9. R

    Tiling quadrant shower enclosure

    Hi, I have done a bit of tiling before but I will be tiling our shower room soon and we have a 800 x 800 quadrant shower. The tiles we like are 400mm wide. We also prefer the look of them lining up and not in a brickwork pattern. How would be best to tile the shower as I have seen the corners...
  10. C

    tilling onto wood in shower room

    hi, im looking to put right a mistake that was made previously in a shower room. i have a 1400 shower tray in a room that is 1480 wide, so at the end of the shower there was a gap that had been filled in with ply and then tiled over, this failed and i have taken the tiles off. my question is how...
  11. Spbeatpoet

    Ditra over shower pan

    Aloha everyone. I've embarked on a bathroom remodel. I opted to use the hydro block shower pan and system. When I notched my joists and set my presloped pan, I've ended up flush with the existing wood subfloor. As such, now if I put any hardi board on top of subfloor, the transition to the...
  12. M

    Slope problem in installed shower

    Looks like I didn't get the slope correct on this shower bed. Here's water not drained after 10 hours since turning off the shower. How atrocious is my fix going to have to be? Be honest. I can handle it.
  13. T

    Silicon seal base and corners of a walk in shower? Currently grouted

    Bathroom fitters finishing job tomorrow, is it necessary for them to seal around the base and corners before they leave?
  14. R

    Cracked tile in shower

    Hello We recently had our bathroom renovated. We have a walk-in shower, so the tiles are the same in the shower and the bathroom floor. One of the porcelain tiles (large format: 800x800x10mm) has cracked by the walk-in shower. The tile was cut (‘L’ shape cut) to fit the wet room kit. The crack...
  15. J

    Upstand shower trays

    Hi. Just thinking about shower trays. Do shower trays with an integrated upstand require sealing where tiles sit upon the tray? I wondered if this type of tray (if Silicon is not required) would be better suited to a bathroom that has a history of Silicon going mouldy where the tiles touch...
  16. D

    Shower glass pane against skimmed wall and up against tile edge.

    Hi all, This forum has been a wealth of knowledge for me while i tackled our new build. A quick question please regarding wetroom wall tiles and a glass partition. Where the wall tile meets the glass partition (tile will finish here and not go beyond the glass), do i finish the edge of the...
  17. C

    Tiler required to fix badly installed shower - Canterbury Kent

    We paid to have a new shower room installed just over 2 years ago. They fitted a false plasterboard wall in order to make a smaller shower base fit more easily and then tiled straight over the plasterboard. Recently some of the tiles have fallen off the wall (600x300). I removed the front of the...
  18. N

    Advice please - Epoxy resin shower corners

    I have been searching for information on internal corners joints for shower. I have epoxy resin which I have used to join mitred tiles on a difficult angle external corner. Is I OK to use epoxy resin in joint on internal corners? I plan to use epoxy grout for remainder of shower. The shower has...
  19. S

    Mastik failing quickly in marble tiled shower

    Hi, I recently had a contractor strip out and replace all the Mastik in my shower as it had failed. It was a very poor job and not colour matched. The new contractor did a good job, or appeared tom with a matched colour (Jasmine) but less than two months on it has completely failed, coming away...
  20. S

    Tanking shower walls and sealing around the existing shower tray

    I have just joined the forum and I'm hoping for some advice. I had a leak in my shower which now needs retiling. I have replaced the area of water damaged plasterboard with a sheet of aquapanel. The shower tray is remaining in place and I am now planning to tank/waterproof the three walls that...

Advertisement

Top