waterproof

It is ideally suited for use on floors and walls, under Tiles and Stone. Made from soft woven polyethylene, it is easy to roll out and fit into corners of the room. The tiles are laid directly on the shower liner with the appropriate bedding for the chosen tile or stone. Continue reading...

This white grout pen is ideal for giving the bathroom tiles a mini makeover. LONG LASTING INK: These white grout pen for tiles are ideal for small or big DIY projects. Toys & Baby. GREAT VALUE PRODUCTS that don’t break the bank. Continue reading...

Can anyone recommend a ready-to-use waterproof grout for an elderly diy-er to attempt to repair grout in beige bathroom tiles please? Thank you in anticipation of any replies.

I need to tile a new corner shower stall. I put Hardi waterproof backer board on the wall and used thinset to seal all my seams and screws, also used thinset for my transition seam between the drywall and backer board. I used a setting joint compound (not a pre mix drywall compound) to feather...

My builder has laid floor tiles in our bathroom - including in the shower area and has asked me to get some waterproof grout. I'm not sure if that's the right approach. From the reading I've done, it looks like I could either use normal or water-resistant grout and then add a sealer, or I could...

Hi all, I am hoping to find some help. A false wall has been constructed in my bathroom and two niches have been put into it. The 'wall' has been boarded over with aquapanel cement board and the niches have been constructed with the same. I need to tile the entire bathroom now, but taking it...

I am using Marmox Multiboard on a bathroom floor adjacent to a wet room and rather than using Marmox Self-Adhesive Waterproof tape wonder if there is any reason why I shouldn’t use the Aquapanel equivalent? It is half the price. Thank you.

Hi - Im in the middle of refurbing my daughters ensuite (Jack and Jill), I don't plan to fit a wet room, but when you have teenage daughters im as well making it as waterproof as I can. I have removed all the plasterboard on the walls and replacing with Kerdi board, and I will seal appropriately...

Hi everyone, I'm looking for some advice on final floor buildup. We're installing a shower tray onto ply (with grab addy), it's 1700x800mm so should perform as a wetroom, closed on all sides apart from a bit at the end of one side to get in and out. So my question is about the rest of the...

Hi, a few tiles keep falling off in the shower enclosure. Any tips on the best material to use to replace the plaster. Pink area in the middle. Thinking sand and cement (4/1 parts) or aquapanel piece screwed in. thanks, pras

I am hoping some of the pro's out there can give me some advice what i should do next. Tile backerboard floor and vertical wall. Now what do i do going up to the pitched roof?. My thinking is to tileback board to ceiling and tile but then i am workign against gravity when tiling. Other option...

this is my first property i am renovating. i have made the niche so far from stud and the back i have used 12mm plywood and sealed using ob1 sealant/adhesive. I have already purchased some aquapanels to use. would it be best screw the aquapanel in the niche and use the knauf joint adhesive, then...

Would like recommendations for 300 x 600 (x10mm) porcelain tiles, on wall inside a walk-in shower enclosure, tiling directly onto tile backer board. DIY tiler with limited experience. I think I need a powder adhesive for this size tile, but it needs a long bucket life - had a mare using penny...

I just renovated my en-suit and am left with the following items: 1. 2.6-meter tanking tap 2. Waterproof tanking primer – see arrow for quantity left 3. Waterproof tanking membrane - see arrow for quantity left 4. Weber PR360 styrene acrylate primer- about half left I can accept £20 or near...

Hi, The fibreglass waterproofing under my 10m2 roof terrace has failed and I am getting quotes for this to be replaced with asphalt (more hard-wearing?). On top of this I would like to tile the surface (mosaic/geometric). Is there anything specific I need to tell the roofers to ensure the...

What do people recommend to waterproof shower room. Would you go with cement based boards or backer polystyrene boards? We are also having underfloor heating and would like advise on what to put on the floor as we are not going to have a shower screen. Originally we was just gonna have 6mm...

I have just found this on the US Hardie site, apologies if it’s already common knowledge. Not sure if it will be coming here, but would be something I would consider using. https://www.jameshardie.com/JamesHardieNorthAmerica/media/Products/Hydro/HydroDefense_SellSheet_0419.pdf

I've contemplating filling this with Silicon, but something tells me that's not correct?

I read somewhere not long ago that b&q were set to stock a foam core, waterproof backerboard, well I called in there today for a couple of none work related bits and spotted them. This was in a large Sheffield branch so not sure if the smaller branches have them I read somewhere not long ago...

Been using Mapei WP200 waterproof decoupling membrane for the last 3 wetrooms I’ve done. Must say it’s a really good product and recommend trying it. Easy to get hold of at CTD, 30 metre roll, corner/ transition tapes, internal/external corners available also. Anybody else use it and what is...