I am considering purchasing the Wedi system for a shower renovation.
The current shower setup uses an electric shower and the new shower renovation will also use an electric shower.
The current electric cable runs from the studs, through the tile backer board, through the tile and then into...
Hi all, I am in the middle of renovating my bathroom. First of its kind for me! The walls were are all Plasterboard with tiles around the room up to shoulder height when standing in the bath tub. 2.7 walls on a wooden stud work frame, 1.3 walls relying on dot & dat adhesive against the grey...
I'm hoping someone here can give me some advice!
I'm re-tiling my shower after needing to rip out the previous dodgy plywood backing which failed (right side in the photo) and plasterboard (left side) I'm planning on installing Wedi board as a backing board solution.
For the right side onto...
Hi everyone - we're doing up our house and installing a wetroom, tiles are 8mm 60cm x 120cm porcelain tiles. The floor is timber and the walls are a mixture of timber and brickwork. Would appreciate your advice on what our tiler should be using for the floor and wall substrate - Hardibacker or...
Hi guys. About to start tiling a walk in shower with the wedi pre-formed shower tray installed. What tanking system is considered the best? Ive seen a lot of Impey. They the best?
Good evening,
I’m hoping someone can assist with a question I have regarding tanking over Wedi board.
I’m currently renovating my bathroom and turning it into a wet room. I’ve laid an Impey Aqua Dec-4 former and for the immediate shower area walls I’ve removed the old plasterboard and replaced...
Hi Folks,
if I could pick your brains for an opinion Id be very grateful.
I'm building a bathroom over here in NL In my attic.
Ive battoned between the floor joists, and set 2 layers of 18mm plywood under the shower area. I primed the plywood with a waterproof primer, then set the wedi fundo...
Having a bit of a nightmare here.
I fitted 12.5mm wedi thin bed cement mortar over ply covered stud walls. Taped all joins etc. Tiled. Grouted but the grout I used scratched the surface of my tiles.
I've removed the tiles, the wedi obviously got damaged so I've removed that which was all fun...
Hi all
Looking for some advice on the Wedi system.
I’m installing a Wedi Fundo Riolito Neo 1200 x 800mm former on a suspended timber floor (25mm ply on joists with Wedi board over rest of floor and on walls).
Looking at a number of videos on YouTube it seems in the US that the Wedi trays...
Hi all. Very much a novice so after some advice. I’m planning on renovating my bathroom but unsure on a few things and not getting anywhere fast. Not too sure exactly where to tile. Floor to ceiling or level with the window and follow it round. The back wall which I have aquapanel is definitely...
Hello gents! Long time lurker, first time poster....
I’m just fitting out our en-suite bathroom using Wedi board on three walls and standard plasterboard on the fourth. Most of the Wedi will be plastered and painted with only the shower area being tiled (I’ve used Wedi all round because of the...
I have a fairly small bathroom 2m x 2.2m which will be tiled wall to floor all round. The straight bath will be fitted onto the 2m wall so I will need a tile backing board.
I will be going for porcelain tiles - not sure on the weight but size wise will be 600 x 300.
The bathroom is back to...
Hi team
I have hacked off one tile approx 40cm by 20cm off a bathroom wall that's covered in tiles head to toe
The surface of the wedi behind this tile and it's netting has come off with the tile and it's adhesive. Considering the incredibly small area concerned (one tile), is there a best...
Hi. I posted a thread yesterday but hadn't received any answers. Probably says more about the question than anything else!! Anyway, I have hacked the plaster off the wall so we are back to the blockwork. I'm able to get Wedi board where I am from Topps Tiles, however, they advised me that the...
Currently working on a Wedi installation, was wondering what tile adhesive I could use that would work just as well as Wedi 320, as this seems really tough to get a hold of.
wedi Certification Programme
This is a training programme made up of three interlinked courses;-
Level or step 1 – wedi Wetroom System product demonstration & certification class
Level or step 2 – wedi Building System product demonstration & certification class
Level or step 3 – wedi Wellness &...
I have a new loft conversion, it has green moisture resitant plasterboard in bathroom. i want to fit shower panels bought from bathstore in shower cubicle it has a MDF core with some waterproof coating. Would there be any benefit to installing wedi board on top of the green moisture plasterboard...
This is something I've had my eye on for a while, all the info in the link but it's a comprehensive wedi course at the cost of around £100 including an overnight stay, in Manchester. I thought I would put the feelers out to see if we could get a few people together to attend, later in the year...