wetroom

  1. M

    Raising Shower Floor Questions

    Hi, We recently had a tiler raise an existing shower floor to turn it into a walk-in disabled shower. Unfortunately they stuffed up the fall levels and the water runs out the side and they need to do it again. However we have also since wondered about whether the shower needed to be...
  2. L

    Hi all, i have four showers to tile from scratch, cement board lined.

    I have 20l of Nassboards latex tanking paint but am unsure if a primer is required? The substrate is cement board which is clean and not dusty. If I do need a primer can I use 50/50 PVA or must it be something expensive! I have also been looking for a good value tape for the joints and am put...
  3. M

    correct way to waterproof shower niche

    this is my first property i am renovating. i have made the niche so far from stud and the back i have used 12mm plywood and sealed using ob1 sealant/adhesive. I have already purchased some aquapanels to use. would it be best screw the aquapanel in the niche and use the knauf joint adhesive, then...
  4. M

    Backerboard on top or behind shower tray?

    Hi all, DIYer here. I'll be fitting a new shower tray soon and boarding the walls with Marmox. My intention was to board the walls first then fit the tray, filling any small gap around the tray with a quality sealant (recommendations?). Once tiled, the tiles would overlap the tray, leaving a...
  5. M

    Space around shower tray

    Hi all, I’m about to fit a new walk in shower and have stripped the existing bathroom. The room is 1530 wide by 2100mm long. I intend to fit a 1500 wide shower tray at one end of the room, however, I need to deal with the 30mm of extra space. I can make up the extra 30mm in waterproof...
  6. C

    Layout advice for "brick" layout tiles in walk in shower

    Hello! I am about to lay a walk in shower with 120cm X 20 cm tiles. In general the room will be a "brick" type layout. The walk in shower is closed on 3 sides and borderless on the front. The drain is a hole type drain which is off center, which means I will have to generally cut the 'v...
  7. A

    Narrowboat Bathroom help needed

    Having trouble deciding how to move forward with my live-aboard narrowboat bathroom....I want to construct a shower to take up about half the space of the little room in the picture (there will be a third wall by then also walls will be primed and actually attached and the fire alarm removed) -...
  8. P

    My 1st Job Tanking details: Wetroom floor on joists with flush linear drain and wet UFH.

    Hi, I'm new to the forum (and tiling / bathrooms) and appreciate the many threads that I have been learning from. If anyone had a moment to comment on the tanking and drain plan for my new attic wetroom I would be very grateful. I'm doing all the work myself, learning as I go. I'm most...
  9. M

    Water not flowing to shower drain / Incorrect Fall Levels?

    Hi, We have just done some bathroom modifications privately to level out a shower floor for an elderly disabled bathroom. We just did the shower area and not the whole bathroom (so only the pink tiles are new). The water is flowing outside of the shower, suggesting the fall levels are not...
  10. A

    Setting Out how should I centre in shower with offset mixer

    Kind tilers out there: the back wall of my glass shower cubicle is 990mm but the plumber centred the mixer lever for a 1000mm shower. I am going to tile with a 600 x 300mm tile (in landscape stack), I don't know how to lay it out. Is it better to: 1) have a grout line running plumb from the...
  11. K

    Shower Tray trim vs Silicon

    I'm tiling an en-suite shower (it has one of those bog-standard heavy cast-concrete (?) and enamel bases if that makes a difference). I am not an experienced tiler, so I'm doing my learning. Looking on the YouTubes, nobody seems to be using that concave shower tray trim anymore, (that would go...
  12. A

    Setting Out Tiling a shower

    I have a 995mm x 995mm built in shower in the corner of my small bathroom. The the mixer was not centred properly on wall, so it sits a little off centre. The genebra and shower rail are on the adjoining wall. Should I centre the mixer on the one wall within the 600 x 300 tile and tile outwards...
  13. C

    MX Shower Tray with riser kit issue

    Good morning. I’ve been trying to work out how to stop my shower tray from moving! I’m fitting a complete en-suite and someone before has run the shower waste above the floor boards etc so I have to use a riser kit or build it up. (Floor boards run under the partition into another room). I...
  14. F

    How to fill gap between floor tiles and shower

    Having had my wooden skirting replaced below our shower with some UPVC, I’m left with a 15mm gap between our floor tiles and the new UPVC skirting. The bloke that did the job filled it with wall tile grout and it’s cracked and looks pretty bad Any ideas on how best to fill this gap? Going to...
  15. F

    Mosaic tiles lifting in wetroom

    So we had our bathroom replaced with a wetroom around 6 years ago and where the water hits the floor and where you stand, all the little mosaic tiles started to lift. This was around 2 years ago. We have reapplied adhesive a few times but it just keeps happening, so resorted to pulling them up...
  16. D

    Glass mosiac shower installation

    I am currently tiling a shower area. Field tiles are installed with space for a vertical 300mm vertical feature/ border and a 100mm horizontal border. Both horizontal and vertical borders will be fitted with glass mosiac tiles of different designs but both of a depth of 7mm. I have used the...
  17. D

    My 1st Job First diy basement shower

    Hi. I am a diy. My first job so dont go all crazy on me. I do have an issue, my inside corners have large joins. Its cause wall goes in. How do i best hide it?
  18. M

    Non Slip Shower Tiles

    I will be getting some modifications done to a shower for my mother, who is elderly and disabled. I'll be getting someone to remove the shower screen and raise the shower floor level to be flush with outside. The primary focus is having a non slip surface in the shower. I've been recommended R10...
  19. J

    Shower tray movement - tiles will be ok???

    Have just noticed movement in the steel shower tray at the corner edge. I have tiled the adjoining floor tiles so now am unable to remove the tray from its position as it is butt up against the wall - see photo options - tile onto the tray whilst in its lower position so it can’t rise when...

Advertisement

Top