It depends on the gap left between the tiles. If its a big one like we have seen before then it may need a bead that wide.
Tilers Forums Official Sponsors
It depends on the gap left between the tiles. If its a big one like we have seen before then it may need a bead that wide.
O
One Day
It is if your room isn't square!
B
Blunt Tool
Never thought of that Mark. 😉
B
Blunt Tool
Ok as above and as long as the room is square! Anyone remember monty pythons what has the Romans done for us!
As the tiles are oblong they will only line up one way...
If that's a grout joint by the trim (can't quite make it out).......then it should of been a full tile length to the corner ...
L
LM
Judging by what can be seen from the pics it looks like badly aligned tiles.
B
Bill
The first photo you posted - the tile joint is off set because the tiler started with a full tile from the tile trim on the flat surface (hidden cistern?) which is common practice but the tiler could have put a cut in to line up the joint.
The other joints don't look too bad but those joints could be like that because the tiles may well be different sizes - another common problem. If this is the case then it is impossible to have perfect joint alignment.
There are far, far worse tiling jobs - in fact this is probably an 8.75 out of 10.
The other joints don't look too bad but those joints could be like that because the tiles may well be different sizes - another common problem. If this is the case then it is impossible to have perfect joint alignment.
There are far, far worse tiling jobs - in fact this is probably an 8.75 out of 10.
Imo that would look weirded, 2 small cuts next to a full tile...
Unless I'm looking at it wrong...
Just re -read everything......I was referring to making the best of what was there.
But yes the whole wall to the left could of been worked out to line up the joint.
Which is what I think tom was on about...
I don't know, it's been a long day..🙁
Unless I'm looking at it wrong...
Just re -read everything......I was referring to making the best of what was there.
But yes the whole wall to the left could of been worked out to line up the joint.
Which is what I think tom was on about...
I don't know, it's been a long day..🙁
Last edited:
There are similar tiling threads here
- laubi02
- Tilers Talk - Any Country
