All the things I hate in one bathroom

[macten]

Cheap Turkish metros with no glaze wrap
Discontinued BCT hexagonal marble mosaics for floor which had been stuck to the mesh by boz eyed Bob
Seriously unlevel floor
An alcove
Sloping ceiling
The need to use fine grout (don’t get on with it, can never get it to look anywhere near as good as UC)

All my pet hates in one bathroom!

 

[Andy Allen]

you've missed out the bit where the customer wants a perfect finish !!

 

[Dave]

At least BCT are no more 👍

 

[Old Mod]

Have you not missed out the pictures, or am I being more stupid than normal? 🤷🏻‍♂️😁

 

[Tony_C]

Black grout to top it all off?

 

[Bathfix Bob]

And a living room walkthrough to get to bathroom.

 

[macten]

Have you not missed out the pictures, or am I being more stupid than normal? 🤷🏻‍♂️😁

haha yeah. Not got loads but should be final fixing on Tuesday

 

[Dumbo]

haha yeah. Not got loads but should be final fixing on Tuesday

View attachment 111296 View attachment 111297 View attachment 111298 View attachment 111299 View attachment 111300 View attachment 111301 View attachment 111302 View attachment 111303 View attachment 111305 View attachment 111306

I know you've said before, but what do you make your dams for levelling out of

 

[macten]

Window packers stuck down with rapid at the correct heights make my dots.
sharp sand and cement for the rails.
Just make sure you wet your straight edges when you’re packing down the cement, and use a sliding motion. Cut the excess off the sides and tidy up with a trowel. When you’re happy lift the straight edge off as you slide back and forth and it should leave it perfect.
So they act as both a dam and a datum.
Phil Hobson to thank for this method

 

[Dumbo]

Window packers stuck down with rapid at the correct heights make my dots.
sharp sand and cement for the rails.
Just make sure you wet your straight edges when you’re packing down the cement, and use a sliding motion. Cut the excess off the sides and tidy up with a trowel. When you’re happy lift the straight edge off as you slide back and forth and it should leave it perfect.
So they act as both a dam and a datum.
Phil Hobson to thank for this method

How long do you leave before pouring .

 

[macten]

Usually prep it day before. But I have poured straight away when needed. Just be careful not to stand on the rails while your pouring if you’re doing it before they’ve set.