D
Duchard
I'm about to put some Hardibacker 500 boards up in my wetroom installation and after browsing the forums I'm still unsure as to how to apply these boards. So far its looking like the dot dab plasterboard solution is a defo no no. But then some people mention to dot & dab and screw fix.
I have three bags of plasterboard adhesive left so ideally would use this but again not sure as recommended to use tile adhesive.
If your better to use tile adhesive is any ok? Cement based? Ready mixed? Water proof? Will just any cheap adhesive be ok considering suppliers recommend a full cover to each board.
Also if you need to screw fix does anyone know what the best method is to screw to block. I installed my kitchen to some of these air bricks and they are like butter. Would I need to pre drill the holes and insert raw plugs?
Any help much appreciated on this as like other jobs I want to make sure I do it right the first time.
Ta
I have three bags of plasterboard adhesive left so ideally would use this but again not sure as recommended to use tile adhesive.
If your better to use tile adhesive is any ok? Cement based? Ready mixed? Water proof? Will just any cheap adhesive be ok considering suppliers recommend a full cover to each board.
Also if you need to screw fix does anyone know what the best method is to screw to block. I installed my kitchen to some of these air bricks and they are like butter. Would I need to pre drill the holes and insert raw plugs?
Any help much appreciated on this as like other jobs I want to make sure I do it right the first time.
Ta