UK Tiling Forum; Established 2006

Welcome to the UK Tiling Forum by TilersForums.com, built in 2006 by Tilers, run by Tilers.

View all of the UK tiling forum threads, questions and discussions here.

Went to a customer today to lay 25mt conservertry floor 60 * 45 porcelain from b and q the guy in the store told him you need to use these pegs to get everything flat ( no lipping) he paid about £40 for them what a joke I assured him everything would be fine......topps are going to sell them Ive been told I THINK THEY ARE A LOAD OF *******
 
Went to a customer today to lay 25mt conservertry floor 60 * 45 porcelain from b and q the guy in the store told him you need to use these pegs to get everything flat ( no lipping) he paid about £40 for them what a joke I assured him everything would be fine......topps are going to sell them Ive been told I THINK THEY ARE A LOAD OF *******
Have you tried them!!!
 
Tried them today on the job...... b@q sell them in bags of 20 Used 1 bag to much hassle Never use spacers as a rule.... hard to snap off I think they would cause voids so no solid bed. Its a diy load of ......What people forget is if the floor is flat get the mix right and use a rubber mallet job done
 
Last edited by a moderator:
Knowing B&Q, the pegs will have discrepancies in size so you'll end up with one tile sitting lower than the other through using this method. :lol:
 
Was thinking about trying these out just to see if they were any good .........dont think i'll bother now :thumbsdown:
 

Advertisement

Thread Information

Title
B and Q lash pegs
Prefix
N/A
Forum
UK Tiling Forum
Start date
Last reply date
Replies
12

Advertisement

Tilers Forums Official Sponsors

Thread statistics

Created
robbbin,
Last reply from
J.R Tiling,
Replies
12
Views
10,578

Thread statistics

Created
robbbin,
Last reply from
J.R Tiling,
Replies
12
Views
10,578
Back