Full floor prep

[Gazzer]

Actually seeing the customer later this week and the method i propose on top of the bare joists.
Extra noggins where seems needed
18mm wpb ply screwed down on top
The wet system panels then placed down and also screwed down onto the ply and joists
A latex based slc poured over the panels(2-3mm depth) and the pipe channels
Then finally dural ci matting.
Would that sequence appear to give us the best chance for a long tem instalation.
Cheers again

I would go with Mapei Renovation screed, cheaper than latex based . Good stuff too

 

[kaharrison9]

Will check that out,thanks again.
Was looking at polypipes advise when tiling on top and they just reccommend either tile directly on top with a flexible adhesive or put a 6mm ply down first!
Chatting to a pal who 2 years ago had a polypipe system on a floating floor and he said hardiebacker was screwed on top of the heating panel then tiled and never has had any problems.

 

[Gazzer]

Will check that out,thanks again.
Was looking at polypipes advise when tiling on top and they just reccommend either tile directly on top with a flexible adhesive or put a 6mm ply down first!
Chatting to a pal who 2 years ago had a polypipe system on a floating floor and he said hardiebacker was screwed on top of the heating panel then tiled and never has had any problems.

As long as the pipe system was covered with either SLC or backer board I would be happy. I would have thought SLC and Ditra /Dural Ci would be cheaper and safer than screwwing boards though and a few mm saving too.