Kristol tile cutter anyone tried one?

[Time's Ran Out]

Russian guy sent me the link, works for trump administraton

Only this week! No doubt.

 

[Bill]

the spiral wedges are a great idea

 

[Tony_C]

the spiral wedges are a great idea

You can get spiral wedges over here, I have some from PTT that I am yet to try, but different to them and only go to 10mm and not stackablebut I'd rather just put the cut in than wedge as high as he goes

 

[Balloo]

You can get spiral wedges over here, I have some from PTT that I am yet to try, but different to them and only go to 10mm and not stackablebut I'd rather just put the cut in than wedge as high as he goes

It's probably for skirt tile

 

[widler]

No back buttering, someone is going to die 🙂

 

[Boggs]

Got to get myself some of those open toe safety shoes!

 

[Balloo]

Some of the models run on ball bearings, less friction and smoother motion

 

[Tony_C]

The same as Sigma then 🙂

 

[Tony_C]

I've been watching a few of his videos here and there since you mentioned him a couple weeks back and i added him to my favourites for the morning brew watching, pretty impressive. He also has a nifty looking wet cutter but i have only seen little snippets of it. just wish i knew what he was saying

 

[Balloo]

I've been watching a few of his videos here and there since you mentioned him a couple weeks back and i added him to my favourites for the morning brew watching, pretty impressive. He also has a nifty looking wet cutter but i have only seen little snippets of it. just wish i knew what he was saying

Yeah there's a few Russian guy's on YouTube there preparation is impeccable and also there ATD.
Very high standard, I've been trying the miters on my work and it takes so long to get right with the polishing etc. Feel like going back to the trim instead.