Manual cutter on Porcelain job

[spooner68]

I went to a Rubi day at CTD Cambridge and was told that the breaker can become worn. Instead of having a point that works like the pin hammer on the scribe line it becomes flat and this causes the small breakout at the beginning of the cut or the bad break. I believe that Dave at TT sell replacement breakers. Could be cheaper than a new cutter.

Yeah, just been looking at that. Also the runners seem to be corroding as the rubbers stick a lot and I have to use a Silicon spray to get them moving. Will price up the bits and decide.

 

[spooner68]

Two threads going at once here, been running back and forth on what to do what to buy. Sigma, Monolit, Ti66, Iscii....

Anyway.

For sale one used Rubi TS60 Plus, well run in, one careful hardworking owner, all original parts. Offers? Buyer collects.

I bought the Monolit, it was the bit in the film on TT where the geezer was snapping the inch mosaics that clinched it. Sexy.