new tongue n groove - bathroom

[Pac]

hello again, after that last lot of great help i am back for another question if i may.

i have recently replaced the bathroom floor at my daughters. the floor was left for a week to adjust to room temperature and then isntalled with joist vises. they have been cramped very tightly so it will not shrink and leave gaps.

now i have tiled many floor but as this is the 1st time i have done it on new floorboards, i thought i would ask if there was anything i need to be aware of?

do i just ply sheet the floor as normal and screw it down or is there something else i need to do?

any special thickness of ply? or anything to be aware of?

thanks

 

[Pac]

Hmmm, you a big guy then? 2 sheets is enough for me, 3 at a push!!

erm, normal to me but maybe a little larger than average. i do go to the gym. i'm about 5`11`` and erm..18St 😳

not all fat though, i can bench press just under 22 stone properly without stupid substances because i hate cheaters.

so no, it didn't seem anything untoward to just pick them up but then again, i usually do stupid things like grabbing the missus for a bit of fun and her saying "owe that hurt" :incazzato:

as for the screws, now i am unsure cos one says yes and another says no.

to me, normal screws rust and would react with the adhesive but drywall screws don't. however, the one that said the dry wall screws are brittle is also correct as i have snapped quite a few over the years.

 

[Deleted member 9966]

is there such a thing as galvanised wood screws then Pac? I'm merely a woman who gets confused with stuff like this :lol:

 

[dock]

pretty sure u can get galvanised wood screws...............................nothing wrong with pac's weight......................he's just not tall enough!!

 

[grumpygrouter]

that's cos you is ickle Grumps, but perfectly formed :lol:

:001_icon16::wub:

 

[grumpygrouter]

is there such a thing as galvanised wood screws then Pac? I'm merely a woman who gets confused with stuff like this :lol:

You can get Stainless Steel ones.

 

[jay]

plaster board ones are fine thats why i mentioned fine threads and set screw gun up right:8: