Platform to stand on in small bathroom. Page: 2

[Fekin]

Im doing a bathroom with hign celings, and basically when stood on my step ladders right next to the bath I can only just reach across the width of the bath to place the top tile in the corner of the front of the bath wall, was hard work but did it, though how Im going to grout and Silicon up there is a whole other matter :huh2:

What would you suggest using to place across the bath to stand on.

Something that would take 18stone of pure man :lol: , while obviously I would pad under it, but what would you use.

 

[CJ]

Any good to ya Fekin

http://www.wickes.co.uk/Step-Ladders/Professional-Hop-Up-Platform/invt/170000

 

[Fekin]

No, as there is very little floor space and can only just get my step ladders around the room, the floor space is only 2sqm.

 

[TilingLogistics]

Always used to use 18mm ply cut to bath board size one with side taps cut out and one with end taps cut out. I used to glue anti slip rubber to the bottom and use it as a work platform and table. saved loads of cleaning up in the bath and loads of room to work.

Kev

 

[infidel]

Kev, That's exactly what I use. Works a treat & saves a lot of cleaning up and possible damage to the bath.

Glad to see your still about after your 'ban' from the other place (wink wink)

 

[TilingLogistics]

Kev, That's exactly what I use. Works a treat & saves a lot of cleaning up and possible damage to the bath.

Glad to see your still about after your 'ban' from the other place (wink wink)

I'm going nowhere mate. Except now I am on the best Forum!!! One that is run by an owner with common sense and Mods who can moderate:hurray:

Kev

 

[Branty]

I'm going nowhere mate. Except now I am on the best Forum!!! One that is run by an owner with common sense and Mods who can moderate:hurray:

Kev

Thats a shame!

 

[guy1976]

Thats a shame!

why is it a shame i think he is a excellent member to have on board in all the time i have been on this forum i have never seen any posts by members who specialise in stone restoration and repair and his knowledge will benefit everyone

 

[DHTiling]

Thats a shame!

Why's that dave....?...:huh2:

 

[Gazzer]

Thats a shame!

:huh2::huh2::huh2::huh2:

 

[TilingLogistics]

Thats a shame!

Dave,

Who are you then? No profile listed! But you join the Forum the day after me! Post on nearly every thing I have posted on, then make a comment like that! :stupid:

Kevin Martin
Tiling Logistics