shower room

[brendanbreeze]

Hello all,

Just a quick question...I'm tiling a shower room next week which at the moment just consists of bare plastered walls and an unfitted shower tray in one corner.

My question is this. Is it ok to tile right to the floor behind the shower tray or should I be tiling to the top?

Thanks for reading - Brendan

 

[marc1106]

install the tray first if it has a built in upstand then that should sit into the skimcoat so your tiles sit flush onto the tray

 

[brendanbreeze]

Cheers,

I'm guessing it's a very straight forward job to fit?

 

[doug boardley]

I tile onto shower tray, less chance of leakage imo

 

[marc1106]

depends on the type of tray you have Brendan, some come with adjustable legs others you have to create a stand for but yes once the wastes are in place fitting the tray is not difficult!

 

[brendanbreeze]

Just out of interest. If the shower tray wasn't there, ie hadn't been bought yet. Would you advise getting it before tiling or tile to the floor?

Thanks - Brendan

 

[marc1106]

get it fit it then tile! its the right way to do it if you tile to the floor then fit the tray you WILL have issues later :mad2:

 

[garretridge]

Just out of interest. If the shower tray wasn't there, ie hadn't been bought yet. Would you advise getting it before tiling or tile to the floor?

Thanks - Brendan

you need to fit tray first then tile down 2mm gap for Silicon gives a neat finish!

 

[beanz]

If you tile down to the floor 1st, you're probably gonna be left with a pretty large gap between top of tray and tiles. That's asking a lot of the Silicon, and you're gonna get leaks.

 

[brendanbreeze]

Ok, so definately fit it first. Marc you mention that I may have to create a stand for it? would this be just a few lengths of wood screwed to the floor? what kind of clearance do I need beneath the plug hole?