Sigma or Rubi

[G Taylor Tiling]

Hi,
My now well worn out Rubi TS60+ is ready to retire,
The Question is do I switch from Rubi (Used for 20 years +), I also have, TS 40, TS70+ & TX 1200, & Look at the Sigma range, I have heard alot about these machines,
In America they all use them, But Would like the Opinion, of Professional Tilers who are more than Happy that they have switched sides!
Thanks
Grant

 

[Gazzer]

I switched years ago, Sigma were the ones everyone used in Australia while I was there so i followed. Never looked back and have banged the Sigma drum ever since.

 

[G Taylor Tiling]

Thanks for that,
Any model I should be looking at to replace the same cutting length of TS60+

 

[Gazzer]

A 5a will take 62cm

 

[Eduardo]

I use this Sigma for 20 years,never let me down.

 

[DHTiling]

The 3cm , push cutter , so not to hard to get used from the rubi action..

 

[Jeff the tiler]

Hey agree with above I changed over about 6 months ago though only when my rubi's are wearing out. i have mentioned in the past on larger format tiles would definitely go Sigma but let's say from the rubi ts60 and below on porcelain or ceramics they both perform equally well. Only my view though.

 

[G Taylor Tiling]

Thanks everyone for your input
looking at the Sigma Max series