Sigma Vs Rubi finally solved!!!!!!!!

UK Tiling Forum; Established 2006

Welcome to the UK Tiling Forum by TilersForums.com, built in 2006 by Tilers, run by Tilers.

View all of the UK tiling forum threads, questions and discussions here.

Tilers Forums Official Sponsors

which one did you get Dave?, I've been thinking 3CM to replace my tx700, although I'd probs go for kk handle
 
It was just to see if it could do it Pete, sometimes i am governed on these wetrooms to where the tile finishes at ceiling height as i have to start of the viynal trim with a full tile, so it works what it works to the ceiling.. but my TS will not cut small slivers from a full tile without breaking away but the Sigma does no probs..

I would like to use the pull handle though to see how the smaller foot works etc.
Was hoping I wouldn't ever need to use a manual tile cutter again lol
 
Also gents one to remember. when you change a handle over on a Sigma you must only release the nut on the bar at the base end not where the guide rail is. I had a guy who released both ends and just spun around the whole bar which might knock it out of line. They come calabrated from Italy so just be aware. slide the handle off the bar from the back end then either turn it around or switch the handle over. If your cutter ever goes out of line in the future then its a simple thing to get it right again. (small alen key and spanner) on the guide rail where you see the silver knob where the measurments are. it adlusts from there to get it right again. two min job.

Sorry am i missing something but to replace the handle I have to remove the roll pin too ?

Not that I have a Klick Klock handle to try :thumbsdown:
 
Yes. knock the pin out at the back so the handle slides off. We have a new system out soon where its just a quick release fitting. No more hitting the pin out with hammer.
 

Advertisement

Thread Information

Title
Sigma Vs Rubi finally solved!!!!!!!!
Prefix
N/A
Forum
UK Tiling Forum
Start date
Last reply date
Replies
26

Advertisement

UK Tiling Forum

Thread statistics

Created
ruairi mac,
Last reply from
Gazzer,
Replies
26
Views
17,624

Thread statistics

Created
ruairi mac,
Last reply from
Gazzer,
Replies
26
Views
17,624

Weekly Email Digest

Back