Slc, What's Your Preferred Brand?

[Andy Allen]

Some very diplomatic answer on here well done everyone 🙂

 

[StevieBoy]

Absolutely.

 

[Andy Allen]

However I'm the kind of guy that if it looks like a turd, smells like a turd then it probably is a turd...😉​

 

[widler]

@Wishiwasatoptiler
It went from around 30mm to 1mm in places , when I put the laser round it ran about 50mm out from the corner where no slc is, which was the high spot .it still ran out but I couldn't get it true as it was being run into the hallway which was tiled with plank tiles a few weeks ago by myself (dot and dabbed, one at each end and one in the middle,flat as a pancake it was) .
This house is about 200years old , been gutted ,we plastered it and I've just tiled it all, whoever did the concreting wanted shooting , but like the bloke said, "its reyt Widdy, when I spill me beer it will run to corner, easier to mop up "
Known the man for years , a superb stone mason , he made the fire place , his stone work is top class, his block work is not 🙁

 

[hmtiling]

It's a 4ft speed skim, used by skimmers on sites, I bought one for the lads, they could not get used to it ,it's rubbish on skim, works a absolute treat on self levelling though 🙂
@whitebeam @jobdone

ordered! 🙂

 

[hmtiling]

After finally using rocatex fibre flow i have to agree with the guy who recommended it to me. It's the best slc i've used hands down. Used a lot of floor flex and ultra fibre fx but this is streets ahead for flow rate and the finish is bob on.
Thanks @widler for the speed skim idea, worked a treat!